MOUNTUP MU3004 Dual Monitor Stand Instruction Manual
- June 14, 2024
- MOUNTUP
Table of Contents
- Safety Caution
- Before Starting Assembly
- Hardware Included
- Step 1A Clamp Installation
- Step 1B Grommet Base Installation
- Step 2 Attach the VESA plates to the monitors
- Step 3 Attach the monitors to the stand
- Step 4 Tilting Adjustment
- Step 5 Switch screen horizontally and vertically
- Manage tools and cables
- Set the desired angle of the monitors
- Product dimensions
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
INSTALLATION INSTRUCTION DA-0L
If you have any questions, please feel free to contact Customer Service via Amazon before returning.
Safety Caution
Please read this instruction carefully before installation.
If you do not understand these instructions or have doubts about the safety of
the installation, assembly or use of this product, please contact us.
WARNING: This product contains small items that could be a choking hazard
if swallowed.
KEEP AWAY FROM CHILDREN UNDER 3 YEARS OLD. ADULT SUPERVISION IS REQUIRED.
Before Starting Assembly
When attaching brackets to the flat screen, be careful not to over tighten
screws and be sure that screws do not bottom out in the mounting holes.
Before starting assembly, verify all parts are included and undamaged. For
parts shortage or damage, please contact us. Do not tighten the screws
excessively or your monitor might be damaged.
Hardware Included
Step 1A Clamp Installation
Assemble the upper pole 02A and the lower pole 02B together Secure the L plate 01B to the lower pole 02B with the preassembled screws. Secure the clamp bracket to the L plate with the screws 06
Step 1B Grommet Base Installation
Assemble the upper pole 02A and the lower pole 02B together. Dis-assemble the clamp bracket. the marked parts a and b will be used in next step. Assemble the round plate 01C to the lower pole 02B with the preassembled screws. Position pole assembly on the desk then secure it by tightening the knob bolt after making knob bolt b through the Long plate a , desk hole, and the bottom of pipe assembly sequentially.
Step 2 Attach the VESA plates to the monitors
Step 3 Attach the monitors to the stand
Assemble the monitor heads 03 and the pole toghther. Slide the monitor heads 03 down to desired height and secure them via tightning the bolts Hang the first monitor onto the arm then using the safety screw M-C to secure the monitor and attach the cable clips 07 .
Step 4 Tilting Adjustment
Loosen tilting bolts, pull monitor to your desired angle, then fasten tilting bolts with the 5mm Allen key 05B .
Step 5 Switch screen horizontally and vertically
If needed, the monitor can be rotated ±90 degrees for switching screen between
horizontally and vertically for turn the monitors directly. 360° Rotation
This function works better for monitors with the center of gravity.
Note: To ensure stability, the tightness of the rotation axis is preset,
so it need take some effort to rotate the VESA Plate.
Suggestion: Please attach the monitor first, then hold the two sides of
it with both hands, and rotate vigorously. If that doesn’t work out, please do
not hesitate to ask for our help via Amazon.
Manage tools and cables
Set the desired angle of the monitors
Product dimensions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>