BORMANN BBC8000 Starter and Power Bank Owner’s Manual
- June 4, 2024
- BORMANN
Table of Contents
BORMANN BBC8000 Starter and Power Bank Owner’s Manual
Product Layout
OPERATION GUIDANCE
Indicator Lights
Press the switch button to check the capacity of Jump starter.
| Light Indicator | 1 Flashing | 1 solid | 2 solid | 3 solid | 4 solid |
|---|---|---|---|---|---|
| Battery capacity | 0% | 25% | 50% | 75% | 100% |
When charging, indicator lights will flash one by one. The number of solid indicator lights indicates the battery capacity of Jump starter. Full indicator lights are solid when charging is pause or complete.
Charging for Jump starter itself:
- Plug the home adaptor into the universal socket.
- Connect 12V 1A input port of Jump starter to the other end of home adaptor. Or
- Plug the car adaptor into the socket of cigarette lighter.
- Connect 12V 1A input port of Jump starter to the other end of car adaptor.
For Jump start of 12V vehicle
- Make sure that the number of indicator light is not less than 3.
- Plug the cord of jumper cable into the jump start socket.
- Connect the red battery clamp of jumper cable to the vehicle’ s positive (+) battery terminal and connect the black battery clamp of jumper cable to the vehicle’s negative(-)battery terminal.
- Start the vehicle, and interval time between each starting must be OVER 30s; if after 3 times failure, stop trying again; please check if there are problems of the vehicle engine or circuit, meanwhile, check the jump starter, if problem, please return it to the distributor.
- When the vehicle starts, remove the jumper cable from Jump starter and disconnect and black clamps to the vehicle battery terminals within 30 seconds.
- Leave the vehicle’s engine running.
- Do not jump start petrol cars which displacement is larger than 3.0 L.
For charging to mobile phones or tablets
- Plug the switch cable to USB 5V 2Aoutput port.
- Select appropriate connector for your mobile phones or tablet and connect it to your mobile phone or tablet. Jump Starter can identify and charge the electronic device automatically. The indicator lights will be on when charging.
LED illumination
Press the switch button 3 seconds to start the LED illumination and then 4 modes of LED light appear in sequence (normal. Strobe. SOS. Off) If you press lightly.
Parts List
#
| Parts Name|
Quantity
---|---|---
1| Main product| 1
2| USB Cable| 1
3| Home adaptor| 1
4| Car Adaptor| 1
5| Jumper cable with battery clamp| 1
6| User manual| 1
Technical Specifications
- Size: 13275124mm
- Weight: 288g
- Battery capacity: 8000 mAh
- Input: 12V/1A
- Output: 5V/2A; 12V jump start
- Full charging time: approx 4h
- Start current: 200A
- Peak current: 400A
- Operation temp.: 20″C —60C/-4F —140″F
- Protections: Short circuit proof, overcharge protection and discharge protection
- Lifetime: 1000 cycles
FAQ
Q: How to turn off this appliance?
A: This appliance will power off automatically when no load or charging is complete.
Q: How to turn off this appliance?
A: This appliance will power off automatically when no load or charging is complete.
Q: How many times can this appliance charge for my mobile phone?
A: 4 times at least for iphone 4 mobile phone
Q: How long will this appliance take to charge my mobile phone full?
A: Approx. 1 hour
Q: How many times can this appliance on a full charge to start the vehicle?
A: Approx. 20 times.
Q: How long will the power of battery of this appliance remain?
A: 6-12 months, however, we suggest you recharge it every 3 months.
TROUBLE SHOOTING
Finding
|
Cause
|
Remedies
---|---|---
No response when pressing the switch button
|
Low voltage protection of Jump Starter is started
|
Plug the adaptor into the 12V 1 A input port to activate
TOXIC AND HARMFUL SUBSTANCES
Composition and amount of toxic and harmful substances in Jump Starter.
Pb
|
Hg
|
Cd
|
Cr(Vi)
|
PBB
|
PBDE
---|---|---|---|---|---
0
|
0
|
0
|
0
|
0
|
0
0: Indicate all homogeneous materials’s hazardous substances content are below the MCV limit specified in the standard 2011 /65/EU (RoHS).
Warning
- Do make the blue plug into the Jump starter socket tightly when Jump starter the vehicle. If not, it can’t Jump start the vehicle, and even make the joint melt.
- Do check whether the battery clamps well connected; battery connector rusted, dirty if the vehicle can not be started. Jump start again after cleaning. Do not continue to jump start if 3 times not successfully. If not, it will damage the product. Do check the vehicle for other reasons.
- Do remove the product form the vehicle within 30s. after the vehicle started. If not, it may lead dangerous!
- Do not connect the two clamps. If not, it may lead dangerous.
- Do not decompose product. If not, it may lead dangerous.
- Always take care when using the appliance.
- This appliance is not intended for use by young or infirm persons without supervision.
- Do not use as a toy.
- Do not allow the appliance to become wet.
- Do not immerse the appliance in water.
- Do not operate the appliance in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
- Do not modify or disassemble Jump starter.
- Only a repair technician may repair this unit.
- Do not expose the appliance to heat.
- Do not store in locations where the temperature may exceed 70°C.
- Charge only at ambient temperatures between 0°C and 60°C.
- Charge only using the charger provided with the appliance.
- Under extreme conditions, battery leakage may occur. Carefully wipe the liquid off using a cloth and avoid skin contact when you notice liquid on the batteries. In case of skin or eye contact, rinse immediately within clean water and seek medical attention.
- At the end of their useful life, discard the appliance with due care for our environment.
DISPOSE OF PACKAGING RESPONSIBLY
DO NOT DISPOSE OF ELECTRICAL GOODS IN HOUSEHOLD WASTE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>