MOUNTUP MU4010 Dual Monitor and Laptop Mount User Manual

June 14, 2024
MOUNTUP

MOUNTUP LOGO

MOUNTUP MU4010 Dual Monitor and Laptop Mount

WARNING!

BEFORE ASSEMBLY

  • Layout all components and hardware. Check all parts are included and undamaged.
  • Should anybody intends to install or use this mount, please read and understand this manual carefully.
  • If you do not understand these instructions or have any doubt about the safety instructions, assembly or use of this product, please contact our customer service.

WARNING

  • This product contains small items that could be a choking hazard if swallowed.
  • KEEP AWAY FROM CHILDREN UNDER 3 YEARS OLD. ADULT SUPERVISION IS REQUIRED.
  • Improper installation, such as using the product for monitors over its load capacity or for any purpose not explicitly specified, may cause damage or serious injury. We would not be liable for any damage or injury mounting or caused by improper inappropriate use .

CAUTION AND MAINTENANCE

  • Never allow children to climb, stand, hang, or play on any part of monitor or stand.
  • This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
  • Check that the bracket is secure and safe to use at regular intervals (at least every three months).

PACKAGE CONTENTSMOUNTUP MU4010 Dual Monitor and Laptop Mount
01

ASSEMBLY PARTS

MOUNTUP MU4010 Dual Monitor and Laptop Mount 1 MOUNTUP MU4010 Dual Monitor and Laptop Mount 2

STEP 3: Arm Installation
Install Arm (A), Fixator(H) , Wire Clip (G) on the base in sequence as shown below. Make sure to tighten the Fixator(H) to desired place with 5mm Allen Key(I). Adjust the tightness of the bolt of Arm(A) to make the rotation flexible.MOUNTUP MU4010 Dual Monitor and Laptop Mount
3

STEP 4: Front-panel Installation

Install Laptop Tray (D) to the Arm, Apply pads ( F) to the Laptop Tray (D) to avoid laptop scratches.

MOUNTUP MU4010 Dual Monitor and Laptop Mount 4

  1. Install the top two screws first.
  2. Then attach the laptop trap (D) to arm.
  3. Finally install the next two screws and tighten all screws.

STEP 5 : Attach Monitor MOUNTUP MU4010 Dual Monitor and Laptop Mount
5

STEP 6 : Tilt Adjustment

Problem : If monitor or laptop is facing down

Solution:

  1. Slightly loosen the tilting bolt.
  2. Adjust monitor and laptop tray to your desired tilt angle.
  3. Retighten tilting bolt to secure the monitor and front-panel in place.

MOUNTUP MU4010 Dual Monitor and Laptop Mount 7

STEP 7: Adjust Tension
For intended functioning of the mount, you may need to adjust the tension of Arm (A) in accordance with your monitor weight by 6 mm Allen Key (J).

MOUNTUP MU4010 Dual Monitor and Laptop Mount 8

STEP 8 : Cable Management
Remove bottom plastic covers from gas spring Arm (A) .Run cables from monitor through bottom of gas spring Arm (A). Then cover the Wire Cap (A 1) onto the upper arm of the Arm (A). Reattach plastic covers as shown in diagram.MOUNTUP MU4010 Dual Monitor and Laptop Mount 9

Adjust as Desired

Adjust monitor position and rotation.

  • Tilt
  • Swivel
  • Rotation

MOUNTUP MU4010 Dual Monitor and Laptop Mount 10

Product Dimensions

MOUNTUP MU4010 Dual Monitor and Laptop Mount
11

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals