Waterdrop CNRAH-257760 Fridge Water Filter Refrigerator Water Filter Instruction Manual

Waterdrop CNRAH-257760 Fridge Water Filter Refrigerator Water Filter

Product Information

• Specifications
  • Model: CNRAH-257760, CNRBH-125950
  • Filter Life: Up to 6 months or 200 gallons, whichever comes first (varies based on water condition)
  • Certifications: Tested and Certified by NSF International against NSF/ANSI Standard 42 in model EFF-6032S for the reduction of claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (0.25% lead)

Introduction

A replacement for the following water filters:

Panasonic® filters

• CNRAH-257760
• NRBH-125950

Filter life: up to 6 months or 200 gallons, whichever comes first will vary based on water condition.

Tested and Certified by NSF International against NSF/ANSI Standard 42 in model EFF-6032S for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (<_0.25% lead).

Installation instructions

Before installation

• Shut off the cold-water supply to the refrigerator before installation. Turn on the refrigerator water dispenser to release water pressure, letting water drain from the pipe completely.
• It is normal for black carbon fines (particles) to appear on the outside of your filter. This happens when the filter is jarred in shipping. It is safe to simply wipe it off.
• The filter connectors are larger to prevent leaks. You might have to twist the filter hard to make sure the connection is secure.

1. Remove the drawer and the filter panel.
2. Tilt the water filter slightly upward.
3. Turn the old filter counterclockwise by 90 degrees, and pull it toward you.
4. Install the new filter and rotate it 90 degrees clockwise.
5. Push the water filter down, and put the filter panel back in place.
6. Flush the filter for 5 minutes to clear the system and remove any trapped air.

Maintenance

Storage and maintenance

• Replace your filter every 6 months or 200 gallons to prevent bacteria and fungus growth in your filter, supply lines, and storage tank.
• Keep your unused filters in a cool, dark, and dry place until you need them.
• If you do not use your water dispenser for more than four days, run two gallons of water before using it to prevent bad tasting water.

Frequently Asked Questions

• Q: Why is it difficult to twist the new filter into the filter housing?
  • A: The connector may expand because of water pressure. Therefore, it is recommended you push the new filter in with a little bit of force, but not too hard. Then turn it clockwise.
• Q: Do I need to flush the filter after installation?
  • A: After installation, it is highly recommended you run water for a few minutes before using. Water filters are made from advanced coconut carbon block, so there are some carbon fines in the filter. Flushing removes the carbon fines to produce clean water.
• Q: Must the filter be changed every 6 months?
  • A: Yes, you must replace the filter every six months or sooner if water flow is reduced or if there is heavy sediment / rust present. Over-used filters will degrade the filtration performance.

Warning

• To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer’s specifications and instructions. This filter unit must be replaced every 200 gallons or 6 months. Failure to follow instructions and operating specifications will void your warranty. Further, manufacturer assumes no responsibility or liability for damages arising out of misuse of the product.
• Panasonic® is a registered trademark of Panasonic Corporation.
• Panasonic® is used for reference purposes only.
• The service life mentioned above is subject to chlorine reduction.
• Actual result varies according to the local water quality.

Performance data sheet

• System Model No.: EFF-6032S

Operating specifications

• Operating Temperature: 33°F -100°F/0.6°C – 38°C
• Working Pressure: 20 psi -100 psi/140 kPa – 689 kPa
• Rated Capacity: 200 gallons/757 litres
• Flow Rate: 0.5 gpm/1.9 Ipm

Substance reduction

The system has been tested and certified by the NSF International according to NSF/ANSI Standard 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified by NSF/ANSI Standard 42. While testing was performed under standard laboratory conditions, actual performance may vary.

Substance

|

Inf. Average

| NSF Specified Challenge Concentration| Ave. % Reduction(%)| Average Product Water Concentration| Max Permissible Product Water Concentration| NSF Reduction Requirements| NSF Test Report
---|---|---|---|---|---|---|---
Chlorine Taste and Odor| 2.1 mg/L| 2.0mg/L±10%| 97.0%| 0.063mg/L| N/A| ≥50%| J-00295502

Warning

• Do not use with water that is microbiologically unsafe or of unknown water quality without adequate disinfection before or after the system.
• Systems certified for cyst reduction may be used with disinfected water that may contain filterable cysts.

Manufacturer Technical Support

• Tel: 1-888-352-3558 (U.S.)
• E-mail: [email protected]
• Qingdao Ecopure Filter Co., Ltd.

Made in China

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>