SAVi QK6POE-01 Wi-Fi POE Keypad Installation Guide
- June 14, 2024
- SAVi
Table of Contents
SAVi QK6POE-01 Wi-Fi POE Keypad
Product Information
WARNING: SHOCK HAZARD
This device is intended for installation in accordance with the National Electric Code and local regulations in the United States and the Canadian Electrical Code and local regulations in Canada. If you are unsure or uncomfortable about performing the installation, consult a qualified electrician.
PoE keypad wiring
The PoE 6 Button Keypad requires data and power over a single Ethernet
connection. A PoEcomplient Ethernet switch delivers both data and power over a
standard CAT5e data cable. Installations with non-PoE switches require a PoE-
complient power source, such as the PoE Injector.
- Remove wallplate
- Remove the switch mounting screws
- Carefully remove the switch from the switch box.
- There is a single RJ45 port on the back of the keypad.
IMPORTANT : Ensure Power over Ethernet is rated for 30W at 48V DC
LEDs
When powered correctly via Power over Ethernet, all LEDs will illuminate to
indicate the device is ready to be provisioned.
LEGAL
- Input : 37-57VDC (nominal 48VDC) Operating Ambiant
- Temperature : 0-400C
FOR INDOOR USE ONLY
FCC
- Supplier’s Declaration of Conformity 47 CFR 2.1077 Compliance Information
- Model: QK6POE-01
- Responsible Party – US Contact Information
- 2520 Marsh Lane, Carrollton, TX 75006-2401 214-785-6510
- This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- NOTE : The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.
Please visit savicontrols.com to find the full FCC/IC statements.
This device complies with Part 15 of the FCC Rules and with RSS of Industry Canada. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
- This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.
- This equipment complies with ISED RSS-102 radiation exposure limits set forth for an uncontrolled environment.
- This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body
References
- SAVI I Hello Simplicity I Commercial AV Designer and Manufacturer
- SAVI I Hello Simplicity I Commercial AV Designer and Manufacturer
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>