CREALITY M92 Sprite Extruder Kit User Manual

CREALITY M92 Sprite Extruder Kit User Manual

Parts List

1. Sprite extruder *1
2. Mounting part *1
3. Isolation column *2
4. Teflon tube *1
5. .M38 hexagon socket head screw2
6. Motor extension cable *2
7. Cable ties

Installation Steps

1. Remove the isolation column and Teflon tube from the hotend.

2. Insert the mounting part and isolation columns in the kit into the M5 screws in sequence, then install the original V-wheel and nuts, and tighten them.
   

3. Insert the Teflon tube into the hooted with force,  and the Teflon tube needs to be cut to inappropriate length (83mm is recommended, if there is any change in the heartbreak or hooted, it can be adjusted according to the actual situation). Make sure the cuts are even on both ends of the Teflon tube.
   

4. Install the Sprite extruder into the mounting part from top to bottom as shown in the figure, and insert the Teflon tube into the outlet of the Sprite extruder.
   

5. Secure the Sprite extruder and mounting part together with two M3 * 8 screws.
   

6.  ( Ender-5 Plus Connect the motor extension cable in the kit with the original extrusion motor cable of the printer, and then connect the other end to the stepper motor port of the Sprite extruder.(Ender-5 Plus needs to use 2 motor extension wires)

7. Adjust the printer’s Esteps value to 424.9 (the valueis for reference only and can be fine-tuned according to the actual printing situation), and then click “Store Settings”.
   

8. If the printer does not support adjusting the Esteps value to 424.9, you can create a new text file (txt) and type “M92 E424.9” in the text, press Enter to
   continue typing “M500”. Save the file as the gcodeformat, and copy it into TF card. Insert the TF card into the printer and click to print this file. At this time, the printer’s Esteps value has been adjusted to 424.9.

   ---

Tips：

1. After installation, the printing platform needs to be leveled again.
2. The side adjusting screw on the Sprite Extruder Pro can adjust the clamping degree between theextrusion gear and the filament, forward adjust is tightening and reverse is loosening.
3. The withdrawal distance must be less than 3mm.

MADE IN CHINA

        SHENZHEN CREALITY 3D TECHNOLOGY CO.,LTD.
Official Website: www.creality.com
Business Tel: +86 755-8523 4565
E-mail: cs@creality.com
Company Address: 18th Floor, JinXiuHongDu Building, Meilong Road, Xinniu Community, Minzhi Street, Longhua District, Shenzhen City, China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>