VEVOR SJ-003 Big Mouth Slow Juicer Instruction Manual

VEVOR SJ-003 Big Mouth Slow Juicer

Product Information

Model: SJ-003/SJ-014

The Big Mouth Slow Juicer is a household appliance designed to extract juice from fruits and vegetables. It comes in two models, SJ-003 and SJ-014, with different specifications:

Please note that the appearance of the product may vary from what is shown in the manual, and there may be technology or software updates without prior notification.

Product Usage Instructions

Before operating the Big Mouth Slow Juicer, please read and follow these instructions carefully:

1. To reduce the risk of injury, make sure to read the instruction manual carefully.
2. The unit is designed for household use only. Commercial users are not eligible for the regular warranty.
3. Do not let children play with or use the juicer as it is not a toy.
4. Ensure that the electricity supply is suitable for the unit and use it only as described in the manual.
5. Do not immerse the unit, cord set, and plug into water to prevent electrical shock.
6. Close supervision is required when using the juicer near children.
7. Unplug the unit when not in use and assemble or disassemble it before cleaning.
8. The continuous operation time of the juicer should not exceed 20 minutes.
9. Avoid operating the juicer without any load or overloading it.
10. Do not touch or move any moving parts of the juicer during operation.
11. Only use the pusher provided to push fruits or vegetables into the machine’s chute, and avoid using fingers, spoons, or chopsticks.
12. Do not open the unit while it is operating.
13. Avoid placing the unit near explosives, heated ovens, or hot surfaces.
14. Operate the juicer only on a flat surface.
15. Avoid letting the cords hang over the edge of a table or similar surfaces.
16. Always hold the plug to disconnect it from the power socket.
17. If any parts of the product structure are damaged, especially the safety device and power cord, stop using them and send them to a service center for repair by a qualified technician.
18. This product is not intended for use by persons with weak physical conditions, slow reactions, mental retardation, lack of experience, and common sense, unless they are under supervision or instruction by a responsible individual.

If you have any further questions or need technical support, please feel free to contact us at CustomerService@vevor.com.

We continue to be committed to provide you tools with competitive price.
“Save Half”, “Half Price” or any other similar expressions used by us only represents anestimate of savings you might benefit from buying certain tools with us compared to the major top brands and doses not necessarily mean to cover all categories of tools offered by us. You are kindly reminded to verify carefully when you are placing an order with us if you are actually saving half in comparison with the top major brands.

MODELS

MODEL: SJ-003/SJ-014

This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if there are any technology or software updates on our product.

Warning: To reduce the risk of injury, user must read instructions manual carefully.

SPECIFICATIONS

IMPORTANT

1. The Unit is designed for household use only.
2. Commercial users will not obtain the regular warranty as stated in the terms of the warranty card.
3. This is not a toy. Please do not let children play with it or use it.

IMPORTANT SAFEGUARDS

1. Make sure the electricity supply is suitable for this unit.
2. This unit is intended for household use only. Do not use the unit outdoors or for other purposes than intended.
3. Use the unit only as described in this manual.
4. Do not immerse the unit, cord set, and plug into the water to prevent electrical shock.
5. This is not a toy and should not be used by children. Close supervision is required when the unit is used near children.
6. Ensure to unplug the unit when not in use and assemble or disassemble it before cleaning.
7. The continuous operation time of this product should be within 20 minutes.
8. No-load or overloaded operation of machine is prohibited.
9. Do not touch or move any moving parts during operation of machine.
10. Do not use a finger, spoon, or chopsticks to push fruits or vegetables into the machine’s chute. Only pusher is allowed.
11. Do not open the unit when it is operating.
12. Do not place the unit near explosives, heated ovens, or hot surfaces.
13. Operate the unit only on flat surface.
14. Do not let the cords hang over the edge of table or the like.
15. Please hold the plug to disconnect it from the power socket.
16. If the parts of the product structure are damaged (especially the safety device and power cord), please stop using them and send them to the service center for repair by a qualified technician.
17. This product is not intended to be operated by persons (including children) with weak physical conditions, slow reactions, mental retardation, lack of experience, and common sense unless they are under supervision or instruction by the person responsible for their safety.

NOTE: To avoid hazard of electric shock, unplug the unit from power outlet when not in use or before cleaning. If the supply cord is damaged, stop using immediately and bring it back to service centre for repair.

PARTS DIAGRAM

MODEL: SJ-003

MODEL: SJ-014

USING FOR FIRST TIME

1. Remove all packaging materials, plastic bags and labels.
2. Make sure the electricity supply is 120V~60Hz .
3. Clean the Food Tray / Chute & Strainer Assembly / Squeezing Auger / Juicing Bowl/ Pusher with Soapy water. Then rinse and dry thoroughly.
   • NOTE: DO NOT IMMERSE THE POWER BASE UNIT IN WATER.
4. Assemble the parts per the instruction in the assembling method section. Connect the power cord to the power source.

The unit is ready to use now.

ASSEMBLING METHOD

Please ensure the unit is not plugged in and the switch is turned to the “O” set before assembling the machine.

1. Position the squeezing bowl on the Power base, aligning the spouts and axle position. (Fig 1)
2. Push the squeezing auger firmly into the bowl’s center, ensuring it touches down the bottom or else the cover cannot be closed. (Fig 2)
3. Position the chute on the bowl to align the ▲ to the “ ” and twist it clockwise until it clicks the safety lock. Please make sure that the arrow ▲ on “ ” the cover aligns with the Lock graphic on the Bowl. (Fig 3)
4. Place the juice container and the pulp container under the relevant spouts. (Fig 4)

OPERATION INSTRUCTION

1. Connect the unit with Power.
2. Check and make sure all parts are well assembled in correct position.
3. Make sure the machine is at off “O” position.
4. Make sure the juice and pulp containers are in position.
5. Make sure the juice spout cover is closed.
6. Prepare the fruits or vegetables and cut them into pieces max 5cm x 2cm strips or 3cm x 3cm cubes.
7. Put fruit strips/cubes into the chute.
8. Press the switch to Setting to start thejuicing operation.
9. Push the food down with the pusher only.
10. In case of food gets stuck inside the Bowl, please instantly switch to the “R” reverse function.

NOTE: Please do not use the juicer continuously for longer than 20 minutes.

Open & Close of Juice Spout Cover

• During the juicing process, you could keep the Drip-stop Cover closed before the juice is full in the juicing bowl. (Fig 5)

BENEFITS OF DRIP-STOP COVER

1. To stop dripping at the end of juicing.
2. To mix the juice with different fruits and veggies.

USAGE TIPS

1. Remove hard pits or seeds prior to pressing to prevent possible damage to the squeezing screw.
2. If mixed juices are to be made, please begin with the more complex fruit and then squeeze the soft fruit.
3. Please let the juicer run for 30 seconds after feeding the last ingredient.

ATTENTION

• The juicer is not suitable for juicing very hard or fibrous and starchy fruits or vegetables such as Sugar Cane. There are some fruits which contain too much starch to juice.
• Some examples are Avocado, Bananas, figs, Mango, Papaya, Dragon Fruit, Strawberry, Grape without seeds etc. They will clog up the stainless steel sieve.

DISASSEMBLING METHOD

NOTE

If the juicer gets overheated, it will turn off automatically to protect the machine. In this case, please turn the juicer off “O” . Wait 10 minutes to let the juicer cool down and then turn it on again. To disassemble the unit after use and before cleaning. Please turn the juicer to “O” position and disconnect the juicer from power source. Then, please follow the steps below:

1. Remove the Juice and Pulp containers. (Fig 6)
2. Remove the Chute. Turn the chute anti-clockwise until the ▲ aligns with the “ ” sign. (Fig7)
3. Remove the Squeezing Auger by pulling it out upward. If it is very hard, swing gently and pull. (Fig 8)
4. Remove the Squeezing Bowl by lifting it upward vertically. (Fig 9)

CLEANING & MAINTENANCE

IMPORTANT: Please wash the juicing parts every time immediately after each use. Otherwise, the pulp might stick tightly in Juicing Bowl & Squeezing Auger, affecting the disassembly, cleaning, and juicing performance.

1. Power off the machine and unplug the juicer.
2. Wash the disassembled parts (Fig 10) with water. If the meshes are clogged with pulp, please use the provided cleaning brush to remove the dregs.
   • Attention: Do not use iron wire brush, abrasive or sharp object tool to clean the unit.
   • Please do not use water above 40°C.
3. In case there is any residues remained in the mouth of the pulp spout, please pull
   • out the silicone valve as shown in (Fig 11) below and clean under running water.
   • Press the silicone valve to close it property and tightly after cleaning.
4. To Clean the seal ring in the center of the squeezing bowl, please follow the steps as below:
   • Turn the Squeezing Bowl upside down for easier handling; push the seal ring out with your thumb (Fig 12a) and clean it with water.
   • After cleaning, please put it back in the center hole. The small ribbed surfaceshould face upward (Fig.12b). Make sure the seal ring groove fits well in the squeezing bowl.
   • The big flat size of the seal ring will be inside while the small and ribbed side is outside the Squeezing Bowl. (Fig 12c)
5. Do not put the Power Base into water for cleaning. Wipe it with damp cloth only.
6. After cleaning, please dry the parts thoroughly and store them in a dry, cool place.

STORAGE

• Follow cleaning instructions to maintain the unit before storage well.
• Tidy up the power cord set.
• Keep the unit away from children’s easy access.
• Store the unit and the accessories in a dry, cool place.

NOTE: Please make sure the unit and parts are dry before storing it.

USEFUL TIPS

parts.
2| The ingredient with long fiber needs to be cut down to 5-10 cm thin strips or 3 x 3 cm cubes.| Long fiber food is easy to wind and block the spout.
3| The peel and pits/seeds must be removed from oranges, lemons, grapefruit and melons before use.| The hard pit or seeds may damage the squeezing parts. The peel may block the spout of pulp.
4| Do not use other accessory as a pusher.| It may damage the juicer and cause injury.
5| Each juicing cycle not longer than 20 minutes.| Working over time may cause damage to the motor.
6| Never put the spoon,chopsticks into the opening of the Chute, the juice and pulp spouts.| It may damage the juicer.

TROUBLESHOOTING

Switch to “R” position instantly to make the ingredients return upwards. If the machine still stops running, please clean the machine before use.
Hard fruits or vegetables have not been cut in small pieces.| Hard fruits and vegetables (such as carrot) shall be cut into thin strips or small cubes before putting into chute.
The juice yield is low or juice flows out of the main housing.| The Bowl and the silicone valve are not installed properly.| Please re-install the Bowl silicone valve by referring to the installation method.

Abnormal noise.

| Parts cause extrusion sound during squeezing.| The sound is caused by extrusion of fruits and vegetables, which is normal phenomenon.
The Chute & Strainer Assembly cannot be opened.| There is too much pulps inside the bowl.| Press switch to “R” setting to eject the pulps backward.
There is hard foods stuck inside.| Press switch to “R” to eject the object backward.
The pulp mess is stuck.| Pour water into the Chute to soften the stuck pulp mess overnight.
The container & accessories are dyed after use.| Dyed parts are due to natural color of specific fruits/veggies.| This is natural color and unavoidable.

MORE INFORMATION

• Address: Floor 3-4, Building 7, No. 1, Road Zhengan Western District, Zhongshan City, Guangdong
• Manufacturer: Islow Electric(Zhongshan) Co., Ltd
• Technical Support and E-Warranty Certificate: www.vevor.com/support

NEED HELP? CONTACT US!

• Have product questions? Need technical support? Please feel free to contact us: CustomerService@vevor.com
• Technical Support and E-Warranty Certificate: www.vevor.com/support

Made In China

References

• Contact Us – Official VEVOR Support
• Contact Us – Official VEVOR Support

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>