Gorenje K17BK Kettle Instruction Manual

June 10, 2024
Gorenje

Gorenje - logo K17BK Kettle
Instruction ManualGorenje K17BK Kettle

Instruction manual
K17BK

INSTRUCTIONS FOR USE

  1. Lid
  2.  Lid release button
  3. On/off switch
  4. Base
  5. Mains plug
  6. Water level indicator
  7. Spout
  8. Anti-scale filter

Important
Read these instructions for use carefully before using the appliance and save them for future reference.
Check if the voltage indicated on the base of the kettle corresponds to the local mains voltage before you connect the appliance.
Only use the kettle in combination with its original base.
Always place the base and the kettle on a dry, flat and stable surface.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and  knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and maintenance shall not be made by children unless they are older than 8 and supervised.
Keep the appliance and its cord out of the reach of children. Do not let the mains cord hang over the edge of the table or worktop. Excess cord can be stored in the base  of the appliance.
Keep the cord, the base and the appliance away from hot surfaces. Do not use the appliance if the mains cord, the plug, the base or the appliance itself is damaged.
If the mains cord is damaged, it must always be replaced by Gorenje, a service centre authorised by Gorenje or similarly qualified persons in order to avoid a hazard.
Do not immerse the appliance or the base in water or any other liquid.
The kettle is only meant for boiling water.
Do not use it to heat up soup or other liquids or jarred, bottled or tinned food. Boiling water can cause serious burns. Be careful when the kettle contains hot water.
Never fill the kettle beyond the maximum level indication. If the kettle has been overfilled, boiling water may be ejected  from the spout and cause scalding.
Do not open the lid while the water is boiling. Be careful when you open the lid immediately after the water has boiled: the steam coming out of the kettle is very hot.
Avoid touching the body of the kettle, as it gets very hot during use.
Always lift the kettle by its handle.
Always make sure the water in the kettle at least covers the bottom of the kettle to prevent the kettle from boiling dry.
Some condensation may appear on the base of the kettle. This is perfectly normal and does not mean that the kettle has any defects.
Depending on the hardness of the water in your area, small spots may appear on the heating element of your kettle when you use it. This phenomenon is the result of  scale build-up on the heating element and on the inside of the kettle over time. The harder the water, the faster scale will build up. Scale can occur in different colors.  Although scale is harmless, too much scale can influence the performance of your kettle. Descale your kettle regularly by following the instructions given in the chapter ‘Descaling’.

Electromagnetic fields (EMF)
This Goerner appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual,  the appliance is safe to use based on scientific evidence available today.

This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). This guideline is the frame of a  European wide validity of return and recycling on Waste Electrical and Electronic Equipment.

Boil-dry protection
This kettle is equipped with boil-dry protection.
This device will automatically switch the kettle off if it is accidentally switched on when there is no water or not enough water in it. The on/off switch will stay in ‘on’  position, but the power-on light ring will go out. Set the on/off switch to ‘off ’ and let the kettle cool down for 10 minutes. Then lift the kettle from its base to reset the  boil-dry protection. The kettle is now ready for use again.

Before first use

  1. Remove stickers, if any, from the base or kettle.
  2. Place the base on a dry, stable and flat surface.
  3. Rinse the kettle with water.
  4. Fill the kettle with water up to the maximum level and let it boil once (see ‘Using the appliance’).
  5. Pour out the hot water and rinse the kettle once more.

Using the appliance

  1. Open the lid by pressing the lid release button.

  2. Fill the kettle with water.
    You can fill the kettle either through the spout or through the open lid.

  3. Close the lid.
    Make sure that the lid is properly closed to prevent the kettle from boiling dry.

  4. Place the kettle on its base.

  5. Put the plug in the wall socket.

  6. Set the on/off switch to ‘I’.

The power-on light ring goes on and the kettle starts heating up.
The kettle switches off automatically when the water has reached boiling point.

Cleaning and descaling

Always unplug the appliance before cleaning it.
Do not use any abrasive cleaning agents, scourers etc. to clean the kettle.
Never immerse the kettle or its base in water.

Cleaning the filter
Scale is not harmful to your health but it may give your drink a powdery taste. The antiscald filter prevents scale particles from ending up in your drink and has a mesh  that attracts scale from the water. Clean the anti-scale filter regularly.
The anti-scale filter can be cleaned as follows:

  1. Take the filter out of the kettle.

  2. Clean the mesh by squeezing and rotating it under a running tap.

  3. Gently clean the filter with a soft nylon brush.
    You can also leave the filter in the kettle when descaling the whole appliance (see ‘Descaling the kettle’).
    You can also take the filter out of the kettle and clean it in the dishwasher.

  4. After cleaning the filter under the tap or in the dishwasher, put it back into the kettle by sliding it behind the brackets.

Descaling the kettle
Regular descaling will prolong the life of the kettle.
In case of normal use (up to 5 times a day), the following descaling frequency is recommended:
− Once every 3 months for soft water areas (up to 18 dB).
− Once every month for hard water areas (more than 18 dB).

  1. Fill the kettle with water up to three-quarters of the maximum level and bring the water to the boil.
  2. After the kettle has switched off, add white vinegar (8% acetic acid) to the maximum level.
  3. Leave the solution in the kettle overnight.
  4. Empty the kettle and rinse the inside thoroughly.
  5. Fill the kettle with clean water and boil the water.
  6. Empty the kettle and rinse it with clean water again.

Repeat the procedure if there is still some scale in the kettle.
You can also use an appropriate descale. In that case, follow the instructions on the package of the descale.

Environment
Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment.

Guarantee & service
If you need information or if you have a problem, please contact the Goerner Customer Care Centre in your country (you find its phone number in the worldwide  guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Goerner dealer or contact the Service department of Goerner domestic appliances.

Gorenje - logoGORENJE
WISHES YOU A LOT OF PLEASURE
WHEN USING YOUR APPLIANCE
We reserve the right to any modifications!

Documents / Resources

| Gorenje K17BK Kettle [pdf] Instruction Manual
K17BK Kettle, K17BK, Kettle
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals