ROCAM CR1001E Alarm Clock With USB Charger User Manual
- June 14, 2024
- ROCAM
Table of Contents
THE BEST DECORATION FOR BEDROOM
Alarm Clock with USB Charger
CR1001E
LOCATION OF CONTROLS
1.Set Time Button
2. Hour Button
3. Minute Button
4. Dimmer Button
5.SNOOZE Button
6. Alarm Pause Button
7. Alarm OFF Button
8.Alarm 1 Button| 9. Alarm 2 Button
10. PM Indicator
11.Alarm 1 Indicator
12. Alarm
2 Indicator
13.DST Indicator
14.12/24H & DST
Button| 15.Volume + Button
16. Volume – Button
17.Battery Compartment
18.USB Port
19.DC Jack
20. Speaker
21. Holder (x 2pcs)
---|---|---
Note: Battery is notincluded
POWER RESOURCES
-
Install 2pcs 1.5V “AAA” size batteries to the proper terminals in the battery compartment to memorize the time setting in case of power outage.
NOTE: Batteries(not included) don’t support time display but can memorize time & alarm setting and trigger an alarm in case of AC power failure. -
Connect the adapter line to DCjack, then plug into a 100~240V ACwall power outlet
TIME SETTING
- Press button once, display starts flashing.
- Press button to set the hour. press button toset the minute.
- Press button or button to save time or wait for 5 seconds to confirm automatically.
- To change 12H/24H time format Press button to change 12H/24H time format.
ALARM SETTING
- Press button, the alarm indicator (11) will light up, the display starts flickering.
- Press button to set the hour, press button to set the minute.
- Press button or button to save alarm time or just wait for another 5 seconds to confirm automatically.
- Push or button to adjust alarm volume.
Setting ALARM 2 is the sameas ALARM 1.
Turn off Alarm
When alarm goes off:
-
Press button to pause the alarm, alarm will ring every 9 minutes.
-
Press button to turn off the alarm for today.
Thealarmindicator or is still on, which means alarmis still activated and will ring after 24 hours. -
Cancel Alarm
Press button to turn off alarm1 or alarm 2 permanently.
And corresponding indicator or will disappear.
Alarm 1 will turn off permanently if you press button when Alarm 1 goes off. Similarly, Alarm 2 will turn off permanently if you press button when Alarm 2 goes off.
DIMMER
Repeatedly press button to adjust the brightness of display for your
preference.
Thereis 5 levels, The sequence is as follows:
01-02-03-04-05-04-03-02-01……..
DST
Hold press button to switch to DST format.
DST indicator will turn on.
Hold press button again to turn off DST function.
DST indicator will be off.
USB CHARGING
Plug charging cable into device such as phone or tablet.
Device can charge your phone or tablet at the same time.
The maximum charge currentis 1 Ampere.
Contact our expert:
support@vyelaw.net
Made in Chaina
Version 2.0
Documents / Resources
|
ROCAM CR1001E Alarm Clock With USB
Charger
[pdf] User Manual
CR1001E Alarm Clock With USB Charger, CR1001E, Alarm Clock With USB Charger,
USB Charger, Charger
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>