CREALITY Neo Series Sprite Extruder Kit User Manual

**CREALITY Neo Series Sprite Extruder Kit User Manual

**

Parts List

1. Sprite extruder *1

2. Mounting part *1

3. Isolation column *2

4. Teflon tube *1

5. M38
   M38 hexagon socket head screw*2

6. Motor extension cable *1

7. Cable ties

Installation Steps

1. Remove the isolation column, Teflon tube and enclosure from the hotend.

2. Insert the mounting part and isolation columns in the kit into the M5 screws in sequence, then install the original V-wheel and nuts, and tighten them.
   

3. Insert the Teflon tube into the hosted with force, and the Teflon tube needs to be cut to an appropriate length (85.3mm is recommended, if there is any change in the heartbreak or hooted, it can be adjusted according to the actual situation). Make sure the cuts are even on both ends of the Teflon tube.

4. Install the Sprite extruder into the mounting part from top to bottom as shown in the figure, and insert the Teflon tube into the outlet of the Sprite extruder.

5. Secure the Sprite extruder and mounting part together with two M3 * 8 screws. Then install the stock hotend enclosure.
   

6. Connect the motor extension cable in the kit with the original extrusion motor cable of the printer, and then connect the other end to the stepper motor port of the Sprite extruder.

7. Adjust the printer’s Esteps value to 424.9 (the value is for reference only and can be fine-tuned according to the actual printing situation), and then click “Store Settings”.
   

If the printer does not support adjusting the Esteps value to 424.9, you can create a new text file (txt) and type “M92 E424.9” in the text, press Enter to continue typing “M500”. Save the file as the gcode format, and copy it into TF card. Insert the TF card into the printer and click to print this file. At this time, the printer’s Esteps value has been adjusted to 424.9.

Tips

1. After installation, the printing platform needs to be leveled again.
2. The side adjusting screw on the Sprite Extruder Pro can adjust the clamping degree between the extrusion gear and the filament, forward adjust is tightening and reverse is loosening.
3. The withdrawal distance must be less than 3mm.|
   

SHENZHEN CREALITY 3D TECHNOLOGY CO.,LTD.

Official Website: www.creality.com
Business Tel: +86 755-8523 4565
E-mail: cs@creality.com
Company Address : 18th Floor, JinXiuHongDu Building, Mailing Road, Xingu Community, Munshi Street, Longhead District, Shenzhen City, China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>