Aigostar B09WCZ8GV7 LED Cabinet Light with Motion Sensor Instruction Manual
- June 14, 2024
- aigostar
Table of Contents
Aigostar B09WCZ8GV7 LED Cabinet Light with Motion Sensor
Specifications
Features
- With a 5-way installation (DIY), the LED cabinet light can be also used as a portable light.
- The LED cabinet light with 3 operation modes: switch AUTO(sensor)/OFF/ON.
- Durable and bright SMD LEDs
- Detachable rechargeable USB battery pack, no wiring required, easy to install.
- At AUTO mode, the built-in CDS sensor only allows the LED cabinet light to be activated when it is situated in a dark environment. Once activated, the LED cabinet light will light up when its PIR sensor senses the movement of heat sources such as people or animals within its detection range. The detection range is approx. 3m distance and with 100 degrees angles.
- Suitable for indoor decoration and use anywhere at home, stairway corridor, entrances, basement, kitchen, cabinet, bathroom, bedroom, etc.
Instructions
- Connect the USB battery into the LED cabinet light.
- Set the mode to “AUTO” to use the lamp in motion sensor light mode.
- Set the mode to “ON” to use as continuous light.
- Set the mode to “OFF” to turn off the light.
Attention!
- Product working temperature: 0~35°C, relative humidity: less than 98%.
- Product storage temperature: -10°C ~ 60°C, relative humidity: less than 98%.
Charging instructions
- Connect the micro USB end of the charging cable to the back side of the sensor light and the USB-A end to any available USB adapter charger.
- The red indicator is on when charging and then turns off after a full charge.
- This cabinet light has a 500mAh lithium battery. The time for fully charged is 2 hours and the battery would be damaged if charged for a longer time. The sensor light could work continuously for 6 hours once fully charged. When the light becomes dim, please charge it instead of using it to protect the battery. If the sensor light is not used for a long time, please charge it at least once every month to prolong the battery life.
- Please use LED cabinet light properly. Please do not use it under wet and extremely high-temperature circumstances.
CAUTIONS
- DO NOT IMMERSE THE LED CABINET LIGHT IN WATER OR USE IT IN WET CONDITIONS.
- DO NOT DISASSEMBLE IT BY YOURSELF.
- THE BATTERY IS NOT REPLACEABLE. AT THE END OF THE SENSOR LIGHT LIFETIME, YOU SHOULD REMOVE ALL THE BATTERIES BEFORE DISPOSAL. DO NOT BREAK THE SENSOR LIGHT FORCEFULLY.
- ENSURE THE BATTERIES ARE INSTALLED WITH THE RIGHT POLARITY.
- DISPOSE OF THE BATTERIES BY THE REGULATIONS.
- INDOOR USE ONLY.
- THE LIGHT SOURCE OF THIS DEVICE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE, THE WHOLE DEVICE SHALL BE REPLACED.
- DO NOT LOOK AT THE LIGHT SOURCE DIRECTLY.
AIGOSTAR INTERNATIONAL LIMITED Unit 4 Tees Valley Court Glenarm Road Wynyard TS22 5FE GB GB311003583 http://WWW.AIGOSTAR.COM MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>