AIGOSTAR FG-22048 Night Light With Motion Sensor Instruction Manual

AIGOSTAR FG-22048 Night Light With Motion Sensor Instruction Manual

Product Instruction

Features

1. Thanks to the hook, the sensor light can be either used as a desk light or a hook-on light.
2. The sensor light has 3 operation modes: switch AUTO(sensor)/OFF/ON, easy to use.
3. Durable and bright SMD LEDs.
4. It works with rechargeable battery, no wiring required, easy to install.
5. At AUTO mode, the built-in CDS sensor only allows the sensor light to be activated when it is situated in a dark environment. Once activated, the light will light up when its PIR sensor senses movement of heat source such as people or animals within its detection range. The detection range is approx. 3m distance and with 100 degrees angles.
6. Suitable for indoor decoration and uses anywhere at home, stairway corridor, entrances, basement, kitchen, cabinet, bathroom, bedroom, etc.

Instructions

1. Connect the USB power cable to the DC 5V adapter and then turn it on.
2. Set the mode to “AUTO” to use the lamp in motion sensor light mode.
3. Set the mode to “ON” to use as continuous light on.
4. Set the mode to “OFF” to turn off the light.

Charging instructions

1. Connect the micro USB end of the charging cable into the back side of the sensor light and the USB-A end into any available USB adapter charger.
2. The red indicator is on when charging, and then turns off after a full charge.
3. This sensor light has a 500mAh lithium battery. The time for fully charged is 2 hours and the battery would be damaged if charging for longer time. The sensor light could work continuously for 6 hours once fully charged.

When the light becomes dim, please charge it instead of using so as to protect the battery. If the sensor light is not used for a long time, please charge it at least once every month to prolong the battery life. > Please use the sensor light properly. Please do not use it under wet and extreme high temperature circumstance.

Attention!
Product working temperature: 0~35°C, relative humidity: less than 98%. Product storage temperature: -10°C ~ 60°C, relative humidity: less than 98%.

CAUTIONS

1. DO NOT IMMERSE THE SENSOR LIGHT INTO WATER OR USE IT IN WET CONDITION.
2. DO NOT DISASSEMBLE IT BY YOURSELF.
3. THE BATTERY IS NOT REPLACEABLE. AT THE END OF THE SENSOR LIGHT LIFETIME, YOU SHOULD REMOVE ALL THE BATTERIES BEFORE DISPOSAL. DO NOT BREAK THE SENSOR LIGHT FORCEFULLY.
4. ENSURE THE BATTERIES ARE INSTALLED WITH THE RIGHT POLARITY.
5. DISPOSE OF THE BATTERIES IN ACCORDANCE WITH THE REGULATIONS.
6. INDOOR USE ONLY.
7. THE LIGHT SOURCE OF THIS DEVICE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE, THE WHOLE DEVICE SHALL BE REPLACED.
8. DO NOT LOOK AT THE LIGHT SOURCE DIRECTLY.

PAP

Specifications

AIGOSTAR INTERNATIONAL LIMITED
UNIT 4 TEES VALLEY COURT GLENARM RC WYNYARD TS22 5FE GB GB311003583
http://www.AIGOSTAR.com
MADE IN CHINA

Documents / Resources

| AIGOSTAR FG-22048 Night Light With Motion Sensor [pdf] Instruction Manual
FG-22048 Night Light With Motion Sensor, FG-22048, Night Light With Motion Sensor, Light With Motion Sensor, Motion Sensor Light, Light FG-22048
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>