aigostar FG-04010 LED Bedside Light Instruction Manual
- June 14, 2024
- aigostar
Table of Contents
aigostar FG-04010 LED Bedside Light
Specifications
Instructions
-
Connect the USB power cable to the DC 5V adapter and then turn it on.
-
Put the light in the charging base, then press the lamp until the desired brightness level is reached.
-
The lamp will automatically turn off when charging and will turn on once it is taken out from the charging base (it will last 10 minutes under no operation or you can manually turn it off.)
-
When the charging base power is interrupted, the lamp body will automatically light up with strong light, then the light will be turned off after 10 minutes if there is no other operation. When the power charging is completed, the lamp body will automatically turn off.
-
When the lamp body is taken out from the charging base, the lamp will automatically light up with strong light. You can select low light/strong light/ off by pressing the bottom switch.
-
Put the lamp back into the charging base, the lamp will turn off automatically.
-
There is a fluorescence ring on the charging base which can light up in the dark to find the lamp easily.
-
Smart induction charging base, lamp built-in rechargeable battery, no wiring required, easy to install.
-
The LED light has 2 brightness levels by pushing the top of the lamp or pressing the lamp gray button, easy to use.
-
Durable and bright SMD LEDs
-
Press and hold the bottom button to adjust the brightness level.
-
The light will turn on automatically in case of a power outage for emergency situation.
-
The lamp can be used as a handheld flashlight.
-
Suitable for indoor decoration and use anywhere at home, stairway corridor, entrances, basement, kitchen. cabinet. bathroom. bedroom. etc.
Charging instructions
- Connect the micro USB end of the charging cable to the back side of the sensor light and the USB-A end into any available USB adapter charger.
- The red indicator is on when charging and then turns off after a full charge.
- This lamp has a 650mAh lithium battery. The time for fully charging is 8 hours and the battery would be damaged if charged for a longer time. The LED bedside light could work continuously for 8~28 hours once fully charged.
- When the light becomes dim, please charge it instead of using so as to protect the battery. If the LEDbeside light is not used for a long time, please charge it at least once every month to prolong the battery life.
- Please use the lamp on the flat and smooth desk to avoid falling. Please do not use it under wet and extremely high temperature circumstances.
Attention!
- Product working temperature: 0~40°C, relative humidity: less than 98%.
- Product storage temperature: -10°C ~ 60°C, relative humidity: less than 98%.
CAUTIONS
- DO NOT IMMERSE THE LED BEDSIDE LIGHT IN WATER OR USE IT IN WET CONDITIONS.
- DO NOT DISASSEMBLE IT BY YOURSELF.
- THE BATTERY IS NOT REPLACEABLE. AT THE END OF THE SENSOR LIGHT LIFETIME, YOU SHOULD REMOVE ALL THE BATTERIES BEFORE DISPOSAL DONOT BREAK THE SENSOR LIGHT FORCEFULLY.
- ENSURE THE BATTERIES ARE INSTALLED WITH THE RIGHT POLARITY.
- DISPOSE OF THE BATTERIES IN ACCORDANCE WITH THE REGULATIONS.
- INDOOR USE ONLY.
- THE LIGHT SOURCE OF THIS DEVICE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE, THE WHOLE DEVICE SHALL BE REPLACED.
- DO NOT LOOK AT THE LIGHT SOURCE DIRECTLY.
- AIGOSTAR INTERNATIONAL LIMITED
- Unit 4 Tees Valley Court Glenarm Road Wynyard TS22 5FE GB
- GB311003583
- http://WWW.AIGOSTAR.COM.
- MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>