GORILLA Waterproof Patch and Seal Tape Instructions

GORILLA Waterproof Patch and Seal Tape Instructions

DIRECTIONS:

For best results, apply the tape to a clean surface at room temperature. For underwater repair, rub the area clean with a sponge or cloth to remove debris, algae, etc.

1. Keeping liner on tape, cut tape to desired size. Tape size should be larger than the repair area, extending beyond all edges. Overlapping tape may cause leaks. Round the corners of the patch to provide less chance of tape lifting at corners. When  possible, apply tape to both sides of the repair.
2. Remove the release liner and place tape over desired repair area. Tape cannot be repositioned once applied.
3. Rub entire surface of the tape aggressively, especially the edges. Smooth the patch from the center to outer edges.
4. Hold the patch in place for 2 minutes to ensure good adhesion. If possible, apply weight to the patch for 24  hours.

STORAGE: Store tape on the top and bottom disc at room temperature. Edges of tape may be sticky.

SERVICE TEMP : -70°F – 200°F

Performance will be dependent on surfaces & conditions. Surfaces must be clean, smooth and non-porous. Water must be pressed out from underneath tape. Not for use on seams, applications under pressure (e.g. garden hoses), or automotive applications under the hood. May not adhere to silicone or water- repellent materials. Do not use to hang. Tape must  make complete contact with surface to properly seal. Ensure water and air is pressed out and there are no wrinkles or gaps in the tape. Permanent: may damage surface if removed.

• Applications Temperature: Best at room temperature
  Service Temperature : -70°F to 200°F

• Outdoor: Yes

• Paintable: No

• Moisture Resistant: Yes

• Storage Tips: Store tape on the top and bottom disc at room temperature. Edges of tape may be sticky.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>