DC 6062331 All Terrain Batmobile Remote Control Vehicle Instruction Manual

June 6, 2024
dc

DC 6062331 All Terrain Batmobile Remote Control Vehicle Instruction Manual

Safety Precautions

CAUTION: Hair Entanglement. Tie back and cover hair and secure loose clothing prior to play.

WARNING: CHOKING HAZARD – Small parts. Not suitable for children under three years.

  • Keep hands, hair and loose clothing away from the motor / wheels when power switch is turned on
  • Remove batteries when not in use.
  • Parental guidance is recommended for the play.
  • Keep your toy in your sight so that you can supervise it all the time.
  • New alkaline batteries are recommended to obtain maximum performance.
  • Users should keep strict accordance with the instruction manual while operating the product.
    Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.

Switch button

CONTENTS

  • 1 ALL-TERRAIN BATMOBILE™

  • 1  Controller

  • 1 Instruction Guide

HOW TO INSTALL BATTERIES

  1. Press down on release button (A) to slide down battery cover (B).
  2. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
  3. Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.

Install batteries

HOW TO CHARGE

  1. Turn the vehicle off.
  2. Remove the cover by flipping the latch to the left.
  3. Plug the charging cable into a 5V DC computer outlet.
  4. Blinking LED indicates battery is charging. Solid LED indicates full charge.
  5. ALWAYS REMEMBER to return charging cable and close cover by flipping the latch to the right.

Charging
Charging

NOTE: THE CHARGING CABLE STORAGE COMPARTMENT MUST BE FIRMLY CLOSED BEFORE PLAY TO ENSURE WATER-TIGHT SEA

HOW TO CONNECT THE CONTROLLER

  1. Turn on the vehicle and place it on a flat surface.
  2. Hold the controller near your truck, press the power button and wait until power light stops flashing.
  3. You are ready to drive.
  4. Use the remote control to drive.

Connect controller

CONTROLLER NOT CONNECTING

NOTE: If your truck does not connect to the controller the first time, turn the truck off, turn the controller off and repeat the HOW TO CONNECT THE CONTROLLER instructions.

DRIVING ON WATER

NOTE: Before driving on water ENSURE THE CHARGING CABLE STORAGE COMPARTMENT IS FIRMLY CLOSED. There is no additional preparation required to drive on water. Fully submerging the vehicle in water is not recommended.

HOW TO INSERT BATMAN™

  1. Turn the release catch clockwise.
  2. Open the Batmobile™ canopy.
  3. Insert the Batman™ figure into the Batmobile™.
  4. Close the Batmobile™ canopy.
  5. Lock the canopy by turning the release catch counter-clockwise.

Insert batman

OUT OF RANGE / LOW BATTERY

  1. Controller will beep when you are close to driving out of range.
  2. Drive vehicle toward you until beeping stops.
  3. If beeping continues, this indicates low battery.
  4. Return and immediately fully charge the vehicle.

NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

HOW TO DRIVE

How to drive

HOW TO CORRECT WHEEL ALIGNMENT

Correct wheel alignment

CARE AND MAINTENANCE

Always remove batteries from the controller when it is not being used for a long  period of time. Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.

BATTERY SAFETY INFORMATION

Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

SPECIAL LiFe BATTERY INSTRUCTIONS

Never charge battery unattended. –

  • Charge battery in an isolated area. Keep away from flammable materials. – Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting.
  • Do not disassemble, modify, heat, or short circuit the batteries. Do not place them in fires or leave them in hot places.
  • Do not drop or subject to strong impacts.
  • Do not allow the batteries to get wet.
  • Only charge the batteries with the specified Spin Master™ battery charger.
  • Only use the batteries in the device specified by Spin Master™.
  • Carefully read the instruction guide and use the batteries correctly.
  • In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery.
  • Batteries must be recycled or disposed of properly.

PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product during disassembly. Ensure product is turned off, then use a screw driver to remove all screws. Separate product body halves to expose internal electronics. When battery is visible in its entirety use scissors to cut a single battery wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated, and the battery is free from the rest of the product. Dispose of battery in accordance with  your local battery recycling or disposal laws.

SPECIAL NOTE TO ADULTS

Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired.

FCC STATEMENT

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:

  • Reorient or relocate the receiving antenna
  • Increase the separation between the toy and the radio or the TV
  • Consult the dealer or an experienced TV-radio technician for help.

NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit fcc.spinmaster.com Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

CONTAINS 1 X 6.4V LiFe 700mAh BATTERY PACK AND REQUIRES 2 x 1.5V AAA (LR03) BATTERIES (not included). Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life, it should not be disposed of with other household waste. The Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and  electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.

This toy is only to be connected to equipment bearing either of the following symbols:

  or

www.spinmaster.com

AIRHOGS.COM/BATMANRC

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals