QFX R-24 Portable AM-FM-SW1-SW2 Radio Instruction Manual
- June 4, 2024
- QFX
Table of Contents
QFX R-24 Portable AM-FM-SW1-SW2 Radio
LOCATION OF CONTROL
- HANDLE
- TELESCOPIC ANTENNA
- BANDS SWITCH
- TUNING CONTROL
- VOLUME CONTROL
- SPEAKER
PRECAUTIONS
For AC operation, check that the unit’s operating voltage is identical with your local power supply see (specifications) and use the supplied AC power cord: Do Not use any other type. For the battery operation, operate the unit only on 4.5V DC using three D batteries. The nameplate indication operating voltage, power consumption etc. is located on the rear exterior. Disconnect the AC power cord from the wall outlet when it is not in use for an extended period of time. This unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. When the internal batteries are not to be used, remove them to avoid damage caused by the battery leakage and corrosion. Do Not leave the unit in a location near heat sources, or in a place subject to direct sunlight and excessive dust. Mechanical vibration or shock. Should any solid object or liquid fall into the unit, unplug the unit and remove the batteries, and have the unit checked by qualified personnel before operating it any further.
SPECIFICATIONS
Radio Frequency Range:
- FM : 88-108MHz
- SW1 : 3.2-7.6MHz
- SW2 : 8.9-22MHz
- AM : 530-1600KHz
Sensitivity:
- FM <<22 DB, MW<<80 DB, SW<<30DB
- S/N : >>40DB
Power
- DC : 4.5V (UM-1*3)
- AC : 110V/220V 60/50Hz
- Power Output : 600MW
- Earphone Jack : 3.5MM
WARNING
To prevent fire or shock hazard, Do Not expose the unit to rain or moisture.
To avoid electrical shock, do not open the back. Refer servicing to qualified
personnel only.