ANKER A1761 Portable Power Station User Guide
- June 14, 2024
- Anker
Table of Contents
ANKER A1761 Portable Power Station User Guide
IMPORTANT SAFETY INSTRUCTIONS
WARNING – When using this product, basic precautions should always be followed, including the following:
-
Read all the instructions before using the product.
-
To reduce the risk of injury, close supervision is necessary when the product is used near children.
-
Do not put fingers or hands into the product.
-
Do not expose the product to rain or snow.
-
Use of an attachment not recommended or sold by the product manufacturer may result in a risk of fire, electric shock, or injury.
-
To reduce the risk of damage to the electric plug and cord, pull the plug rather than the cord when disconnecting the product.
-
Do not use the product in excess of its output rating. Overload outputs above rating may result in a risk of fire or injury.
-
Do not use the product or attachment that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
-
Do not operate the product with a damaged cord, plug, or output cable.
-
Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or electric shock.
-
Do not expose the product to fire or high temperatures. Exposure to fire or temperatures above 130°C may cause explosions.
-
To reduce the risk of electric shock, unplug the power pack from the outlet before attempting any instructed servicing.
-
Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.
-
When charging a device, the product may feel warm. This is a normal operating condition and should not be a cause for concern.
-
When charging the internal battery, work in a well-ventilated area and do not restrict ventilation in any way.
-
Do not clean the product with harmful chemicals or detergents.
-
Misuse, dropping, or excessive force may cause product damage.
-
When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
-
Do not use or store the power station in direct sunlight for a long period, such as in a car, cargo bed, or any other place where it will be exposed to high temperatures. Doing so may cause the product to malfunction, deteriorate, or generate heat.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type. -
Disposal of a battery into a fire or hot oven, or mechanically crushing or cutting off a battery, can result in an explosion.
-
Leaving a battery in an extremely high-temperature environment can result in an explosion or leakage of flammable liquid or gas.
-
A battery subjected to extremely low air pressure may cause an explosion or leakage of flammable liquid or gas.
-
Unplug the AC power cable to disconnect from the line voltage
WARNING: GROUNDING INSTRUCTIONS
This product must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electrical current to reduce the risk of electric shock. This product is equipped with a cord with an equipment grounding conductor and a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING – Improper connection of the equipment grounding conductor may result in an electric shock. Check with a qualified electrician if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided with the product. If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
Storage and Maintenance Instructions
- Store the product between 32°F-104°F (0°C-40°C). Avoid exposing the product to rain or using the product in a humid environment.
- To preserve the battery lifespan, charge to 100% after using. If you plan to store your power station, recharge to 100% every 3 months.
- Keep the product on a flat surface when using, charging, and storing.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party.
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1-800-988-7973
RF Exposure Compliance Statement
This equipment complies with the FCC/IC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20 cm between the radiator and your body.
IC Statement
This device complies with Innovation, Science and Economic Development
Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions : (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device’s.
The device complies with RF field strength limits. Users can obtain Canadian information on RF exposure and compliance.
Waste Electrical and Electronic Equipment (WEEE)
This symbol (with or without a solid bar) means that, according to local laws and regulations, your product and/or its battery should be disposed of separately from household waste. When this product reaches the end of its life, the user has the option of handing it over to a competent recycling organization. Proper recycling of your product will protect human health and the environment.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Anker Innovations Limited is under license. Other trademarks and trade names are those of their respective owners
Scan for online support.
Scan to download the Anker app.
support@anker.com
support.mea@anker.com (For Middle East and
Africa Only)
CED-CN@anker.com (4)
CED-CN@anker.com
(UK) +44 (0) 1604 936 200
(DE) +49 (0) 69 9579 7960 (UAE) +971 8000 320:817
+49 (800) 000 2522 (Anker SOLIX)
(Middle East & Africa) +971 529 750 842
(KSA) +966 8008 500 030
(Kuwait) +965 2206 9086
Egypt)+20 8000 000 826 (AU) +61 3 8331 4800 (TR) +90 (850) 460 1414 (RU) +8 (800) 511 8623 (India) +91 1800 3138831 () +86 400 0550 036 (B) 03 4455 7823 (한국) +82 02-1661-9246
@anker_official
@anker_jp
@AnkerDeutschland
@Anker Japan
@Anker
@AnkerOfficial
@Anker_JP
