rusta 772311920101 Christmas Tree with Light User Guide

: June 13, 2024
: RUSTA

Table of Contents

rusta 772311920101 Christmas Tree with Light
SAFETY INSTRUCTIONS
STORAGE
RIGHT OF COMPLAINT
ASSEMBLY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

rusta 772311920101 Christmas Tree with Light

Thank you for choosing to purchase a product from Rusta!
Read through the entire manual before installation and use!

Christmas tree with lights
Read the user manual carefully to make sure that the product is assembled, used and maintained correctly, as described in the instructions in this user manual. Keep the user manual for future reference.

SAFETY INSTRUCTIONS

Read these use and assembly instructions carefully before you as-semble the Christmas tree. Save them for future reference.
The Christmas tree must be assembled by an adult.
The Christmas tree is intended for indoor use only.
Due to the risk of cuts or crush injuries, be careful when you assemble the Christmas tree.
Do not place the Christmas tree near open flames or embers (such as candles).
Always keep the Christmas tree under supervision when the tree lighting is on.
Place the Christmas tree on a level surface, and make sure it is standing stabile.
Keep watch over small children when they are near the Christmas tree.
Small children can easily put Christmas decorations in their mouths.
Do not overload the Christmas tree with heavy decorations.

WARNING!
If these instructions are not followed, an accident may lead to serious personal injury or property damage.

IMPORTANT

Do not connect the light to the power source whilst still in the package.
The electric cord for this light cannot be replaced. If the cord is damaged, the entire product must be discarded.
The light can only be used with the transformer included in this package.
Do not connect the light electrically to any other lighting.
These lamps cannot be replaced, but have a life span of approximately 10,000 hours.

STORAGE

Save the packaging to store the Christmas tree in.
Remove all the decorations.
Starting from the top, take apart each section. Fold the branches against the stem.
Use water to clean the branches and stem if necessary. Never use solvents to clean the tree.
Place the tree parts in the packaging, with the longest parts on the bottom.
Store the package in a cool, dry place – not exceeding 30° C.

RIGHT OF COMPLAINT

By law the product must be returned to the place of purchase along with the original receipt in the event of a complaint. The user is liable for any damage to the product that is caused by not using the product for its intended purpose or by not following this user manual correctly. The right of complaint will not apply in these instances.

INFORMATION ABOUT HAZARDOUS WASTE
Used products should be handled separately from household waste. They should be taken for recycling in accordance with local rules for waste management.

ASSEMBLY

NOTE!
The assembly illustrations can differ for each Christmas tree model. Depending on the model you purchased, each package has an upper and lower section, and the larger models have a middle section. The plastic Christmas tree stand is included in the package. Unpack the parts and remove any plastic material and tape.

The plastic Christmas tree stand is assembled so the supports fit into the notches of the pedestal (from the bottom and up). The slanting sides of the supports must face up. Tap gently on the feet with a rubber mallet so that the feet are secure.
Insert the middle part of the tree into the trunk of the body and connect the light chain’s stack plug. Then insert the tree top into the trunk and connect the stack plug.
Fold out the branches carefully. Straighten and separate the branches, and then bend them upwards.

rusta-772311920101-Christmas-Tree-with-Light-FIG-3