Laird Tflex HD90000 Series Silicone Based Thermal Gap Filler User Guide
- June 13, 2024
- Laird
Table of Contents
Telex HD90000 Series Silicone Based Thermal Gap Filler
User Guide
Tflex HD90000 Series Silicone Based Thermal Gap Filler
Tflex HD90000 Recommended Directions for Use
Shelf Life:
Shelf life for Telex HD90000 is 1 year from date of shipment at the storage
conditions specified below.
Storage Conditions:
Recommended storage conditions are 0-35°C at relative humidity of 50% maximum.
Please store in original product packaging until ready for use.
Product Form:
Sheets
Application Instructions:
-
Liner for Telex HD90000
Bottom liner: white point embossed liner or diamond liner & PET combined liner
Top liner: 1mil PE liner with Laird logo Liner option is based on customer application request. -
To apply, remove the PE liner first by peeling it back in one swift, consistent motion, and then die cut.
-
Fold the die cut gap filler and make it separate from white point embossed liner or diamond & PET combined liner.
-
Peel off the gap filler from the combined liner and place the pad onto the desired substrate. Note that the light, visible and consistent residue on the liner is normal for this material and it will not affect the gap filler’s performance. A light diamond embossing on pad surface is expected due to materials’ high compliancy. The light gray stripe on material surface is normal and will not affect material thermal performance.
-
Cover the exposed gap filler or continue the assembly process to avoid contamination of the surface with dust and debris.
Part removal Instructions:
- With a converted part lying flat on a solid surface, remove top red diamond liner.
- While holding the part down to the table, place a thin steel tool on an angle and slowly slide the tool underneath the entire part.
- When the tool is at or very close to the cut edge mark, reduce the angle of the tool and raise the tool away from the pad. Lifting the part away from the bottom carrier liner while supporting the complete part.
- Tool size may need adjusted based on the part geometry.
Revision Log
| Rev. | Summary of Change | Requested By | Approval Date |
|---|---|---|---|
| A | Initial Release | Jingbo Shen | 9/29/2017 |
| B | Add tool use to remove parts | T. Kuhn | 9/29/2020 |
A17165-00，Rev A，09/15/2015，
DCO 000567
Documents / Resources
|
Laird Tflex HD90000 Series Silicone Based Thermal Gap
Filler
[pdf] User Guide
Tflex HD90000 Series Silicone Based Thermal Gap Filler, Tflex HD90000 Series,
Silicone Based Thermal Gap Filler, Based Thermal Gap Filler, Thermal Gap
Filler, Gap Filler
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>