My Life My Shop MM40178-2300 Digital Body Scale Instruction Manual

My Life My Shop MM40178-2300 Digital Body Scale

Specifications

• PRODUCT NAME: Balance2 Digital Body Scale (MM40178-2300)
• DIMENSIONS APPROX.: 75 in x 12.25 in x 1.5 in
• NET WEIGHT: 2.9 lb.
• MEASUREMENT UNITS: Kilogram / Pound
• MEASUREMENT RANGE : 5 kg to 180 kg / 11 lb. to 396 lb.
• GRADUATION KG: 1kg ; lb:0.2lb
• INDICATOR DEVIATION: ±1kg (about 1.5 degree)
• POWER SOURCE : 3 – AAA Batteries (4.5V)

Introduction

The My Life My Shop Balance 2 Digital Body Scale combines technology, design, and function flawlessly. The platform is made of natural bamboo and would seem quite at home in a tranquil day spa. The analogue display, which is combined with an LCD digital reading, has a certain nostalgic appeal. The My Life My Shop Balance 2 Digital Body Scale can weigh up to 396 pounds and measures weight in both pounds and kilograms. With a 24-hour reminder setting and a backlit display that makes it simple to see in any lighting condition, you’ll remember to weigh yourself every day at the same time for the most reliable reading.

SAFETY INFORMATION

This Balance2 Digital Body Scale allows you to track your weight. This device is intended for adult use only and is not intended for use by infants or children. This device is designed for home use only.

CAUTION

Read this user manual thoroughly before use. This device is designed and manufactured to operate within defined design limits. Misuse may result in harm. The following should be observed to best use and maintain your device This device is intended for adult use only. This device is intended solely to monitor and determine weight. Its sole function is measurement. Monitoring weight with this device does not equate to a medical diagnosis. Keep the unit out of reach of infants or children. Use only accessories and detachable parts specified and authorized by the manufacturer. Not doing so may cause damage to the unit or danger to you. Avoid using this device on slippery wet floors or while you are wet. Do not store this device where it can be exposed to extreme temperatures, humidity, moisture, sunlight, dust or where you Store chemicals and cleaners.

GETTING STARTED

Open the battery compartment on the back of the scale and insert 3 fresh AAA batteries. Note the correct position of positive (+) and negative (-) battery terminals.

The LCD will fully display for 5 seconds then turn off.

To activate calibration, tap the center of the scale once and then release. When “0.0” is displayed on the LCD, the calibration is complete.

Note: When re-inserting or replacing batteries, please follow above

Step 3 to activate calibration.

Selecting Your Unit of Measure

The scale is pre-set to calculate weight in pounds. Press the unit switch on the bottom of the scale to change the weighing mode between pounds and kilograms.

INITIALIZING YOUR SCALE

The first time you use your scale and anytime you move your scale, if will need to be initialized so that it weighs your properly. After installing the batteries, follow these quick steps to initialize your scale.

1. Place your scale on a hard, flat surface (not carpet).
2. Press down on the center of the platform with your foot, and then lift your foot off.
3. The LCD will display “0.0” and then turn off.
4. Once the display turns off, the scale is ready for Use.

To weigh yourself, simply step on the scale to take your measurement.

Measuring

1. Make sure your scale is on a hard flat surface, not carpet, and has been initialized.
2. Step directly onto the platform and the scale will automatically power on for weight measurement.
3. Keep as still as possible. The LCD display will flash 3 times and show your weight.
4. Indicated weight will display for approximately 15 seconds while you are standing on the scale.
5. If you step off the scale, indicated weight will disappear and the display will go dark after 5 seconds to conserve battery power.

Note -If the scale is turned on and no measurement is taken, it will shut of automatically after 5 seconds.

SETTING UP REMINDERS

Turning On the Reminder Setting

Choose a convenient time of day for your weigh-in. Turn the scale over and press the button (24H/Alarm), an alarm icon () will display on the LCD indicating that the alarm has been set. The alarm will beep at the same time every 24 hours to remind you weigh-in.

Turning Off the Reminder

Press the (24H/Alarm) button again, and the alarm icon will disappear on the LCD.

Stopping the Alarm

When the alarm beeps, simply step on the scale to silence the alarm. If no measurement is taken, the alarm will automatically shut off after about 25 seconds.

DEVICE COMPONENTS

Components Included

1. Balance2 Digital Body Scale
2. Instruction Manual

LCD DISPLAY

Display Components

1. Digital Readout
2. Unit Indicator
3. Analog Readout in Pounds
4. Analog Readout in Kilograms
5. Analog Weight Indication Needle

ERROR MESSAGES

Frequently Asked Questions

How accurate is this scale?

This scale is pretty accurate.

What is the color of the wood finish?

It is something in the middle with a bamboo finish.

Is this perfectly flat or is the wood contoured?

It is perfectly flat.

Can this scale be calibrated at home?

Yes, it’s quite easy. A small knob is located at the bottom. When not in use, all you have to do is turn the tiny knob clockwise or counterclockwise until the scale’s dial is precisely at zero. The scale will occasionally deviate from zero after extensive use, and all it takes to return it back to zero is to “calibrate” it.

What color is the backlight on this scale?

White.

Where is it made?

It is made in China.

What are the dimensions of this scale?

The dimensions of this scale are 15.75 in x 12.25 in x 1.5 in.

Are digital body scales accurate?

These scales use either mechanical weight measurement using springs or electrical weight measurement using circuits that flex underweight and change the current flowing through them. Mechanical bathroom scales are typically less accurate than digital ones.

Can I weigh hot cups or plates?

It is not recommended to place hot cups or plates.

Does the top surface have a circular cutout for the display or is it covered by a flat, solid piece of glass?

The entire surface is solid and flat. In no way is the display cut off. The display is flush with the surface, to put it another way.

Can we choose how long it stays on before turning off?

No.

Does this scale, like the Vitamix scale, specifically relate to Vitamix blenders?

No.

Is glass present on the unit and tare buttons?

No, the unit and tare buttons are not protected by glass. They are made of black plastic and are easily kept clean by just wiping them off.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>