Midea C5 MBC1270GB Vacuum Cleaner User Manual
- June 13, 2024
- Midea
Table of Contents
INSTRUCTION MANUAL
C5 MBC1270GB Vacuum Cleaner
VACUUM CLEANER C5
MBC1270GB
PLEASE READ THE MANUAL CAREFULLY BEFORE USING AND KEEP IT PROPERLY FOR FUTURE USE
Warning notices: Before using this product, please read this manual carefully and keep it for future reference. The design and specifications are subject to change without prior notice for product improvement. Consult with your dealer or manufacturer for details.
Safety Introduction
- For the first operation, it is advisable to read the manual carefully before hand and keep it properly for future use.
- Before the first operation, make sure the dust cup or the dust bag is properly installed.
- Make sure the power supply is 220-240W 50-60Hz
- Do not vacuum water and inflammable material.
- Do not vacuum burning material and ashes.
- Do not use the machine without a motor protection filter filled.
- Please change the dust bag immediately when it was damaged.
- Do not store or use the machine close to high temperature places.
- Dot not let children use the machine in case of danger.
- If abnormal noise, smell, smoke or any other failure or breakage is found during the operation, you should turn off the switch and unplug it. Then contact with your service center for repair. Do not repair by yourself.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
Warning :
The plug must be removed from the power socket before any maintenance or
replacement If the power cord is damaged, replace them only by the factory or
maintenance center or similarly qualified persons.
GETTING TO KNOW YOUR CLEANER
a. Main cleaner | d. Pipes |
---|---|
b. Hose | e. Round brush |
c. Floor brush | f. Crevice nozzle |
Product operation
-
BEFORE FIRST USE
1. Unpack the device.
2. After taking out all the parts from package, please check for possible transport damage immediately. If your product is damaged or incomplete, please contact our after-sales service. -
PRODUCT USE
When first use, your product may give off a slight odor, it is normal. The smell will only be temporary and will wear off quickly.
Illustrations 1 to 17:
III1. Connect the pipes. Diameters are different at both ends.
III2. Connect the pipe to floor brush.
III3. Connect the hose handle to the pipe.
III4. Insert the end of hose into the suction base in the front of dust bin. Turn the end of the hose clockwise watch, until the hose engages properly.
III5. Pull out the power cord to the desired length, then connect the plug to socket.
III6. Switch on: press the on / off button.
III7. Push the floor brush back and forth to clean the floor.
III8. Thanks to the slide on the handle, you can adjust the suction power with it.
III9. Switch off: press the on / off switch.
III10. Unplug the cable and press the button to wind the cord.
III11. Hard floor: push down the button on the floor brush.
III12. Carpet: push up the button on the floor brush.
III13. During rest or storage, you can hang the floor brush on the back of the vacuum cleaner.
III14. Thanks to the extra nozzles supplied, you can clean the joints and cushions.
III15. To take off the suction hose, turn the end of the hose counterclockwise and pull it out.
III16. Take off the dust bin: press the release button.
III17. Empty the dust bin: press the locker to open the bottom cover of the dust bin. -
CLEANING AND MAINTENANCE
This type of vacuum cleaner requires regular maintenance to remove dust.
Warning! Before cleaning, be sure to turn off the power. Always unplug the power cord from the outlet and allow the appliance to cool down before cleaning it.
Warning! Never immerse the electrical parts of the device in water or any other liquid during cleaning or operation. Never expose electrical parts to water.
1. Clean the device with a soft, slightly damp cloth. Make sure that no moisture gets into the device while cleaning it.
2. Never use corrosive detergents, a wire brush, abrasive scouring pad, metal, or sharp tools to clean your machine.
3. Dry the device completely after cleaning.
Filter maintenance: To obtain an optimal suction power, we advise to
clean the internal filters at each empty. The exhaust filter should also be
cleaned regularly, especially when the suction volume is declining.
Illustrations from 18 to 24:
III18: Turn the cover of the dust bin counterclockwise to disassemble.
III19: Turn the inner filter screen counterclockwise to disassemble.
III20: Clean the grid and filter with a small brush.
III21: Wash the filter in water. Let the filter dry completely before
reassembly..
III22: When you reassemble the filter, the arrows on the two parts should
point towards each other
III23: You can remove the air outlet filter to clean it. Hold the button at
the top of the frame and pull it back.
III24: Rinse the filter in water. Let the filter dry completely before
reassembly.
Storage :
Store the device in a cool, dry place out of the reach of children and pets.
TROUBLESHOOTING
In case of malfunction, please refer to the following table
Problem | Possible reason | Solution |
---|
The vacuum
cleaner does
not switch on| -Too much dust in the dust bin
-Filter is blocked
– Brush duct is blocked
-Hasn’t been fully dried after washing| – Empty the dust bin in time
– Clean the sponge filter
– Clean the blockage
– Dry the sponge filter in cool place after washing
The machine
does not work| -The power plugs are loose on the socket or the power socket is
not live
-The switch fails to be opened| – Inspect whether power plugs are tight or not or the socket is live or not
– Press the switch button
The machine
suddenly stops| – The dust bin is full
– The sponge filter is blocked
– Suction inlet of brush or the other accessory is blocked| – Empty the dust
bin in time
– Clean the sponge filter
– Clean the blockage
Brand| Midea
---|---
Series| C5
Model| MBC1270GB
Power| 700W
Rating| 220-240V~50-60Hz
Annual Energy| 27kWh/yr (Class A)
Capacity| 1.5L
Power cord| 4.5m
Filter| EPA10
GW| 350200350mm
Product size| 4.9kg
|
Importer: AB S.A. Adres: ul. Europejska
4, 55-040 Magnice, Polska
Manufacturer: Jiangsu Midea Cleaning Appliances Co., Ltd
No.39, Caohu Avenue, Xiangcheng Zone, Suzhou, China
Made in China
Documents / Resources
|
Midea C5 MBC1270GB Vacuum
Cleaner
[pdf] User Manual
C5 MBC1270GB Vacuum Cleaner, C5 MBC1270GB, Vacuum Cleaner, Cleaner
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>