RUGGED RIDGE 11580.01 Rear 2 Receiver Hitch Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 11580.01 Rear 2 Receiver Hitch
Product Information
- Product Name: Rear 2 Receiver Hitch
- Compatible with: 55-86 Jeep CJ models
- Part Number: 11580.01
- Manufacturer: Rugged Ridge
- Manufacturer Address: 460 Horizon Dr. Suite 400, Suwanee, GA 30024
- Contact Information: Phone: 770-614-6101 | Fax: 770-614-6069 |Email: info@omix-ada.com
Product Usage Instructions
- Step 1: Remove the factory rear bumper or bumperettes and brackets if equipped. If necessary, the rear body mount and bolt can be removed to ease installation.
- Step 2: Align the inner and outer mounting holes of the rear frame cross member. There should be two outside of the frame rail and two inside the frame rail for each side. Use the provided 10mm bolts, washers, and nuts. Torque the bolts to 50 ft-lbs.
- Step 3: Place the rear bumper onto the mounting brackets and attach it through the top and bottom of the brackets using the provided 12mm bolts, flat washers, lock washers, and nuts. Two flat spacers are included to be placed between the bumper tab and hitch. Tighten to 50 lbs torque. The location of the bumper can be adjusted up or down if a body lift has been installed. Please note that if the bumper is not a Rugged Ridge product, there may be fitment problems.
Installation Instructions Rear 2″ Receiver Hitch 55-86 Jeep CJ models
P/N: 11580.01
Hardware
- (1) Rear Bumper
- (8) 10mm Nuts
- (4) 12mm Bolts
- (4) 12 mm Lock Washers
- (2) Rear mounting Brackets L-R
- (16) 10mm Flat Washers
- (8) 12mm Flat Washers
- (8) 10mm Bolts
- (8) 10mm Lock Washers
Installation
WARNING: IT IS RECOMMENDED NOT TO EXCEED ANY TONGUE WEIGHT IN EXCESS OF 200LBS
-
Step (1)
Remove factory rear bumper or bumperettes and brackets if equipped. The rear body mount and bolt can be removed to ease installation if needed.
-
Step (2)
Align inner and outer mounting holes with the rear frame cross member. (2 outside of frame rail, and 2 inside frame rail for each side).
Use the 10mm bolt washer, and nut. Torque bolts to 50 ft-lbs.
-
Step (3)
Locate rear bumper onto the mounting brackets an attach through the top and bottom of the brackets with (4) 12mm bolts, flat washers, lock washers, and nuts supplied.
NOTE: two flat spacers have been supplied to be placed between bumper tab and hitch Tighten to 50lbs torque. Location can be moved up or down if a body lift has been installed. NOTE: If the bumper is not a Rugged Ridge product, there could be fitment problems.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix- ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>