RUGGED RIDGE 13201.11 Driver Side Front Seat Adapter 97-02 Wrangler Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 13201.11 Driver Side Front Seat Adapter 97-02 Wrangler
Product Information
The product is a seat riser frame manufactured by Rugged Ridge. It is designed to securely attach a seat to the frame of a vehicle. The frame is made in Taiwan and comes with the necessary hardware for installation.
Contact Information:
- Company: Rugged Ridge
- Address: 460 Horizon Dr. Suite 400, Suwanee, GA 30024
- Phone: 770-614-6101
- Fax: 770-614-6069
- Email: info@omix-ada.com
Product Usage Instructions
- Attach the seat riser frame to the seat riser using the included hardware.
- Ensure the seat is properly aligned with the frame.
- Securely tighten all hardware using wrenches.
- Remove the bolts from Step 1 that were holding the previous seat to the floor of the vehicle.
- Mount the new seat into the vehicle by attaching the seat riser with new Smittybilt Seat to the floor using the bolts removed in Step 4.
IMPORTANT NOTICE:
Carefully read the instructions before attempting to install this product.
Rugged Ridge is in no way responsible for any damage to the vehicle or
personal injury that may occur during the installation or use of this product.
INCLUDED COMPONENTS
- 1- Frame
- 4 – Bolts (3/8-16×1”)
- 4 – Nyloc Nuts
- 8 – Washers
INSTALLATION INSTRUCTIONS
-
Remove the four bolts attaching your old driver’s side seat with old seat risers (seat riser pictured in Figure 2) to the vehicle’s floor.
NOTE: Save the bolts for later usage. -
Remove the old seat with seat riser from vehicle and place it on a working area.
-
Locate the four bolts that mount the seat riser to your ol&seat and remove these bolts.
NOTE: Save these bolts for later usage. -
Remove the old seat from the seat riser
-
Loosely attach the Frame to the seat riser using the bolts removed in step 4 (Figures 1 & 2).
NOTE: Make sure you keep the original seat riser orientation. -
Once the Frame is attached to the seat riser, proceed to attach seat to the Frame using the included hardware (Figures 3 & 4).
-
Securely tighten all hardware using wrenches. Figure 4
-
Mount your new seat into your vehicle by attaching the seat riser with new Smittybilt Seat to the floor using the bolts removed in Step 1.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix- ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>