Plastica SSW MOU 23 Chop Saw Instructions
- June 13, 2024
- Plastica
Table of Contents
SSW MOU 23 Chop Saw
Product Information
The product is an extruder machine used for a specific process.
It requires a water inlet for proper functioning and maintaining
pressure flow. The machine is equipped with a yellow handle that
controls the water flow. Safety boots are mandatory when operating
the machine. The user manual emphasizes the importance of following
safety procedures and receiving proper training.
Product Usage Instructions
-
Ensure you are wearing safety boots before operating the
machine. -
Locate the water inlet lever, which is identified by a yellow
handle. -
Turn off the water inlet lever by moving it to the off
position. -
Release the hose clip and remove the inlet pipe from the
machine. -
Turn the water flow back on using the inlet lever.
-
Direct the water flow into a clean white barrel to empty any
contents. -
Wait until the maximum flow of water has been achieved.
-
Reassemble the inlet pipe and secure it with the pipe
clip. -
By following the above steps, the low pressure water problem on
the extruder should be resolved, and the pressure flow should be
regained.
Note: Do not attempt to use any steps unless you have been
trained and authorized by a manager. Always prioritize your safety
and report any issues with the machinery to your supervisor or
manager immediately.
Safe System of Work RESOLVING LOW PRESSURE WATER PROBLEM ON THE EXTRUDERS
Name: ……………………………………………………….. Training Date:……………………………..
Instruction
Understood or X
1
Explain that safety equipment must be used at all times and why
safety boots must be used at all times when running machines
2
Turn off the water inlet lever, the yellow handle, release hose clip,
remove inlet pipe.
Turn the water flow back on using the inlet lever, empty any
contents into a clean white barrel, when maximum flow has been
achieved, reassemble pipe and pipe clip, this should now rectify the
problem and you should now regain the pressure flow.
8
9
Do not use any steps unless trained and authorised by Manager.
I have received the above training and fully understand every point that was
explained to me. I confirm that I will wear the required PPE equipment when
using the above machinery and take all steps to ensure my own safety. I will
ask for further training if I need to and will immediately inform the
Supervisor or Manager if there are any issues with the machinery.
Name: ………………………………………………………………………………………………………….
Signed: ……………………………………………………………….. Date:…………………………………
I confirm that I have trained the aforementioned person and that they fully
understand how to use the above machinery, have received the required PPE
equipment and know to inform me immediately of any issues with the machinery
or if they require further training. I authorise this person to use the
machinery detailed above.
Name: ………………………………………………………………………………….(Authorised Trainer)
Signed …………………………………………………………………… Date: ……………………………
SSW MOU 23 06/01/21
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>