RUGGED RIDGE IS-TMRD-01 Trail Mirror Round JL and Gladiator User Manual

June 13, 2024
RUGGED RIDGE

RUGGED RIDGE IS-TMRD-01 Trail Mirror Round JL and Gladiator

RUGGED-RIDGE-IS-TMRD-01-Trail-Mirror-Round-JL-and-Gladiator-
product

Product Information

  • Product Name: Trail Mirror, Round; JL & Gladiator
  • Part Number: IS-TMRD-01 Part # 11025.23
  • Component List:
    • Round Mirror (1)
    • Mirror Arm (2)
    • M12 Jam Nut (3)
    • Mounting Stud (4)
  • Manufacturer: Omix-ADA
  • Address: 460 HORIZON DR. SUITE 400, SUWANEE, GA 30024
  • Phone: 770-614-6101
  • Fax: 844-270-0593
  • Website: www.Omix-ADA.com

Product Usage Instructions

  1. Remove the nut on the windshield hinge and replace it with the Mounting Stud.
  2. Loosely install the M12 Jam Nut and Mirror Arm on the Mounting Stud.
  3. Install the Round Mirror on the Mirror Arm and rotate the arm to the desired position.
  4. While holding the Mirror Arm in place, tighten the M12 Jam Nut until it is tight against the Mirror Arm.
  5. If necessary, loosen the Phillips head screws on the back of the Round Mirror to adjust its position.
  6. Tighten the screws when the mirror is in the correct position.

Components

RUGGED-RIDGE-IS-TMRD-01-Trail-Mirror-Round-JL-and-Gladiator-
fig-1

  1. Round Mirror
    • (11025.23 – 1)
    • (11025.25 – 2)
  2. Mirror Arm
    • (11025.23 – 1)
    • (11025.25 – 2)
  3. M12 Jam Nut
    • (11025.23 – 1)
    • (11025.25 – 2)
  4. Mounting Stud
    • (11025.23 – 1)
    • (11025.25 – 2)

Installation Instructions

RUGGED-RIDGE-IS-TMRD-01-Trail-Mirror-Round-JL-and-Gladiator-
fig-2

  1. Remove nut on windshield hinge and replace with Mounting Stud.
    • WARNING: TORQUE TO 7.5 LB •FT (90 LB •IN)
    • Do not use Mirror Arm to position Mirror. May cause vehicle damage!
  2. Loosely install M12 Jam Nut and Mirror Arm on Mounting Stud.
  3. Install Round Mirror on Mirror Arm and rotate arm to desired position. While holding Mirror Arm in place, tighten M12 Jam Nut until it is tight against Mirror Arm.
  4. If necessary, loosen Phillips head screws on back of Round Mirror to adjust. Tighten screws when mirror is in correct position.

Contact

OMIX-ADA® TECHNICAL SUPPORT

FOR WARRANTY OR TECH CONCERNS EMAIL: webmaster@omixsupport.com

Copyright © 2018 Omix-Ada®, Inc.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

RUGGED RIDGE User Manuals

Related Manuals