RUGGED RIDGE IS-QRSTMRT-01 Quick Release Stubby Trail Mirror Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
Quick Release/Stubby Trail Mirror, Rectangle
IS-QRSTMRT-01 Quick Release Stubby Trail Mirror
Components
-
Mounting Bracket
-
Thumb Screw
-
Bushing
-
M8 Bolt
-
Arm
-
Mirror
-
For JK (07-17): Using T40, Torx Wrench, remove two upper windshield bracket bolts.
For TJ (96-06): Using T40 Torx Wrench, remove two flush mount torx head bolts just in front of door hinge. -
Using supplied hardware, install Mounting Bracket with welded nut facing down.
-
Attach Arm to Bushing. Using Thumb Screw, loosely install Bushing and Arm into Mounting Bracket.
-
Attach Mirror to flat side of MArm using Mirror’s hardware. Tighten screws on the back of the Mirror.
Mirror should be tighten but able to be adjusted if needed.
WARNING For TJs (97-06), it is recommended to use quick release mirrors without doors on vehicle. -
When doors are reinstalled remove Arm from bracket. Place Bushings back into Mounting Bracket and tighten Thumb Screw.
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100
SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>