RUGGED RIDGE 11230.13 Elite Pivotal Headlight Euro Guard Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
Elite Pivotal Headlight Euro Guard
PATENT PENDING
IS-ELGPH-01
Part# 11230.13
11230.17
CONTENTS
- Pinitol Headlight Guard (2)
TOOLS REQUIRED
- T15 Torx Screwdriver
NOTICE
Careful attention is required to this instruction or operation, but does not
generally relate to personel injury. Damage to your product or other property
may result if you do not follow instructions.
-
Disconnect factory turn signal from behind grille. Rotate bulb assembly down and towards center of vehicle. Pull bulb assembly out of turn signal housing.
-
Raise hood and remove (6) plastic pop rivets. First pull up on center pin to disengage rivets, then pull entire pop rivet up and out of grille.
-
Pull bottom of grille away from vehicle to disengage metal clips on bottom rear of grille.
NOTICE
Removal of winch or other bumper mounted accessories prior to removing grille may be necessary. Use caution to prevent damaging finish of grille. -
Remove factory headlight retaining ring using T15 Torx Screwdriver. Do not discard factory screws.
-
Install Pinitol Headlight Guard using factory screws in one of three configurations, vertical, horizontal, or diagonal. Each guard will work for both headlights.
Note: Image shown using left side headlight. -
Reinstall grille and turn signal bulbs.
NOTICE
If removed, reinstall winch or other bumper mounted accessories.
OMIX-ADA®
TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION
VISIT: www.Omix-Ada.com
Copyright © 2016 Omix-Ada® , Inc.
460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>