RUGGED RIDGE 11002.20 Heated Mirrors Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 11002.20 Heated Mirrors
Product Information
Product Name Heating Element and Switch for Heated Mirrors
Part Number 11002.20
Manufacturer :Omix-ADA
Address 460 Horizon Dr. Suite 400, Suwanee, GA 30024
Contact Information Phone –
770-614-6101, Fax –
770-614-6069,
Email – info@omix-ada.com
Product Usage Instructions
- Locate the black negative lead wire and the red positive lead wires that exit from the bottom of the heated side mirror.
- Connect the black wire to a good grounding point located near the doors on the tub of the vehicle. This step should be done for both sides, and the best grounding points are usually located on the tub of the vehicle.
- Connect the red wire to the 12V power lead coming from the supplied switch.
- Find a suitable spot on your vehicle’s dash or console for mounting the switch.
- Thread all wires leading from the switch through the mounting hole before making any wire connections.
- Separate the red and black wires attached to the switch. These wires were initially connected for packaging purposes.
- Connect the solid red wires to a 12V power source. This source can be a constant source or one that is supplied only when the ignition key is in the on position. Note that most vehicle fuse blocks have an extra 12V power source.
- Connect the two 12V output lines (black-red) wires to the red power leads at each mirror’s base. Each mirror will require one power supply line.
- Extra wire has been supplied for any additional wiring needs.
- To turn on the heated mirrors, press the switch with the white button marked flush with the switch base.
Heating Element and Switch Wiring for Heated Mirrors
-
Locate the black negative lead wire and thered positive lead wires that exit from the bottom of the heated side mirror.
Connect the black wire to a good grounding point located near the doors on the tub of the vehicle. This will need to be done for both sides. The best grounding points will be located on the tub.
The red wire will be connected to the 12V power lead coming from the supplied switch.
-
Locate a good spot on your vehicles dash or console for the switch location. All wires leading from the switch will need to be threaded through the mounting hole before any wire connections can be made. The switch supplied comes from the factory with the red and black wires attached. This was done for packaging and will need to be separated before proceeding with The installation. The solid red wires will be connected to a 12V power source. This source can be a constant source or one that is supplied only when the ignition key is in the on position.
NOTE: Most vehicle fuse blocks will contain an extra 12v power source. The two solid red power leads will need to be combined with the connectors supplied. The 12V supply from your Jeep® will need to be connected after the two wires have been joined. Connect the two 12V output lines (black-red) wires to the red power leads at each mirrors base. Each mirror will need one power supply line. Extra wire has been supplied for any additional wiring needs. To turn heated mirrors on the switch should be pressed with white button mark flush with switch base.
460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE 770-614-6101
FAX 770-614-6069
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>