RUGGED RIDGE 13551.16 Dash Multi Mount Phone Kit Installation Guide

RUGGED RIDGE 13551.16 Dash Multi Mount Phone Kit

Product Information

The Dash Multi-Mount Phone Kit, JK is a versatile accessory designed to securely hold your phone or other accessories in your vehicle’s dashboard storage area. It comes with several components:

• Accessory Mount Base – 1 piece
• Rubber Tray – 1 piece
• Universal Ball Mount – 1 piece
• Cap Piece – 1 piece

It also requires the following tools for installation:

• Socket Driver
• 7 mm Socket

Product Usage Instructions

Installation:

1. Remove the factory rubber tray from the dashboard storage area above the center console.
2. Using a socket driver and a 7 mm socket, remove the factory screw. Keep the factory screw as it will be reused during installation.
3. Snap the hooks on the arms of the Accessory Mount Base into the upper dashboard vents closest to the windshield.
4. Reinstall the factory screw removed in Step 2.
5. Place the custom Rubber Tray into the dashboard storage area.

Note : Make sure to read all instructions thoroughly before installation.

Removal of Accessory Dash Mount Organizer:

1. Remove the custom rubber tray from the dashboard storage area.
2. Using a socket driver and a 7 mm socket, remove the factory screw.
3. Rotate the Mount Base towards the windshield until the hooked arms release from the dashboard vents.
4. Replace the factory screw and factory rubber tray back into the dash storage area.

Configurations for Accessory Dash Mount Organizer:

The Accessory Dash Mount Organizer can be configured in four ways:

1. No Accessory
2. Universal Ball Only
3. Tripod Screw Only
4. Universal Ball and Tripod Screw

Mounting a Phone:

1. Place the Outer Ring over the end of the Ball Mount.
2. Press the Phone Mount adapter piece into the Ball Mount.
3. Pull the Outer Ring over the Phone Mount adapter and twist to secure.

Components

• Accessory Mount Base (1)
• Rubber Tray (1)
• Universal Ball Mount (1)
• Cap Piece (1)

Required Tools:

1. Socket Driver
2. 7 mm Socket

DASH MULTI-MOUNT PHONE KIT

1. Remove the factory rubber tray from the dashboard storage area above the center console.
2. Remove the factory screw using a socket driver and a 7 mm socket. Do not discard the factory screw, it will be reused in product installation.
3. Install Accessory Mount Base. Hooks on the arms of the Accessory Mount Base will snap into upper dashboard vents closest to the windshield.
4. Reinstall the factory screw removed in Step 2.
5. Place the custom Rubber Tray into the dashboard storage area.

To remove the Accessory Dash Mount Organizer

1. Remove the custom rubber tray from the dashboard storage area.
2. Remove the factory screw using a socket driver and 7 mm socket.
3. Rotate Mount Base towards the windshield until hooked arms release from dashboard vents.
4. Replace the factory screw and factory rubber tray in the dash storage area.

Four Configurations for Accessory Dash Mount Organizer

INSTRUCTION

1. Place the Outer Ring over the end of the Ball Mount.
2. Press the Phone Mount adapter piece into the Ball Mount.
3. Pull the Outer Ring over the Phone Mount adapter and twist to secure it.

460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE : 770-614-6101
FAX : 770-614-6069 info@omix- ada.com

References

• Health. Powered by Ada.
• OMIX Jeep Replacement Parts - OEM & Vintage Aftermarket Jeep Parts | Omix

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>