RUGGED RIDGE 11585.06 LED Third Brake Light Ring Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 11585.06 LED Third Brake Light Ring Instruction Manual
LED Third Brake Light Ring
-
. Remove spare tire
! CAUTION Have another person help lift tire on wheel mount -
Remove four screws securing factory third brake light mount to tire carrier.
-
Remove seven screws securing backing plate to third brake light mount.
LED Third Brake Light Ring
-
Disconnect battery and cut factory third brake light wires 6” from plug.
WARNING When removing battery cables do not touch positive and negative terminals together. -
Install LED Third Brake Light Ring on tire carrier
NOTICE This product is designed for press fitment. It is not unusual to require a forceful push to install. -
Slide supplied heat shrink over LED Third Brake Light Ring wire loom and splice LED Third Brake Light Ring in place using supplied heat shrink butt connectors.
WARNINGLED Ring is not a DOT approved third brake light. Check with state and federal ordinances regarding third brake light use -
Use supplied heat shrink to seal wire loom to wires. Reconnect battery and depress brake pedal to check for brake light functionality
-
Install spare tire and torque lug nuts to factory specification.
CAUTION Have another person help lift tire on wheel mount.
! WARNING Failure to tighten lug nuts to proper torque specification could result in serious injury or property damage.
Copyright © 2018 Omix-Ada®, Inc