RUGGED RIDGE 11540.23 Modular XHD Bumper Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
Part# 11540.23
2007+ Jeep® JK Wrangler Modular XHD Front Stubby Ends
Installation Guide
Contents
-
Left Stubby End (1)
-
Right Stubby End (1)
-
Lock Nut (6)
-
Washers (6)
-
Stubby Ends are easier to install with the Center Section of Modular XHD Bumper off of the vehicle, but can be installed with the Center Section already installed. If Stubby Ends are replacing the previously installed Filler Plates (Figure 1a), remove them so that empty ends remain (Figure 1b).
-
Position Stubby Ends to the ends of the Center Section, aligning the studs in the Stubby Ends with the holes in the sides of the Center Section. Insert the studs of the Stubby End into the holes in the Center Section and secure them with the supplied washers and locking nuts.
-
Once all 6 nuts have been started, tighten them. Installation is now complete!
Congratulations on the purchase and installation of a quality Rugged Ridge product! Ask your retailer about the following additional accessories to the JK Modular XHD Bumper:
460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>