RUGGED RIDGE 2003-2006 TJ CB Radio Mount Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 2003-2006 TJ CB Radio Mount
CONTENTS
- CB Radio Mount (1)
HARDWARE
- Well Nut (2)
- Long Screw (2)
- Short Screw (2)
- Washer (2)
- Locknut (2)
TOOLS REQUIRED
- Drill
- 23/64” Drill Bit
- Phillips Head
- Screwdriver
- Utility Knife
NOTICE
Careful attention is required to this instruction or operation, but does not
generally relate to pesonal injury. Damage to your product or other property
may result if you do not follow instructions
CB Radio Mount, 2003-2006 TJ/LJ
- Retract soft top, position sun visors against side windows, and pry off plastic windshield trim by gently pulling along it until all clips release.
- Drill out head of rivets holding footman loop in place using 23/64” drill bit and remove footman loop.NOTICE Use caution when drilling out rivets to not drill through windshield frame.
- Clean area and insert well nuts in newly drilled holes. Collapse well nuts by screwing in long screws provided. Remove screws before proceeding
- Align mounting holes and install CB Radio Mount on windshield frame. Place footman loop over CB Radio Mount and fasten to frame with long screws provided.
- Cut off center tab on plastic windshield trim with a utility knife and reinstall on windshield frame.NOTICE Use caution when cutting tab to ensure no damage is done to trim.
- Install CB Radio using short screws, washers, and locknuts supplied.
NOTE : Be sure not to obstruct rear view mirror
Copyright 2016 Omix-Ada®, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>