RUGGED RIDGE 13557.09 CB Dash Mount Kit Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 13557.09 CB Dash Mount Kit
Product Information
- Product Name: 13551.09 Dash Mount CB KIT
- Installation Instructions: 1997-2006 TJ/LJ Dash Mount CB Kit
Contents
- (1) CB Mounting Bracket
- (1) Mic Mounting bracket
- (1) Foam Pad
- (2) M4 Hex Bolt (long)
- (4) M4 Flat Washers
- (4) M4 Nuts
- (2) M4 Hex Bolts (short)
- (1) 1 3/4 Phillips Head Screw (Long)
- (2) 1Phillips Head Screw (Short)
Product Usage Instructions
- Before mounting the CB dash bracket, install the CB mounting base (not supplied). This bracket should be supplied with the CB.
- Locate the two side screws securing the TJ dash side panel. Remove the screws and discard them.
- Place the CB mounting plate on the dash. Line up the two mounting holes and secure using the (2) 1 Phillips head screws.
- If you want to use the CB mic mount, remove the Phillips head screw located to the right of the steering wheel. Use (2) M4 bolts and nuts to secure the CB mic holder to the bracket (mic bracket not supplied).
- This bracket should be supplied with the CB. New mic bracket mounting holes may need to be drilled if holes do not line up.
- Secure the mic mounting plate using the supplied 1 3/4 Phillips head screw.
- Mount the CB to the bracket and follow the CB installation instructions for proper wiring and operation.
- If the CB mount makes contact with the dash after the CB has been mounted, use the supplied foam pad. The pad should be attached between the bracket and dash as shown.
For any further assistance or information, please contact: 460 HORIZON DR.
SUITE 400 | SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
Email: info@omix-ada.com
Step 1
Before mounting CB dash bracket install CB mounting base (not supplied). This
bracket should be supplied with CB.
Step 2
Locate the two side screws securing TJ dash side panel. Remove screws and
discard.
Step 2
Locate the two side screws securing TJ dash side panel. Remove screws and
discard.
Step 4
(Optional CB Mic Mount) If CB mic mount is to be used remove the Phillips head
screw located to the right of the steering wheel. Use (2) M4 bolts and nuts to
secure CB mic holder to bracket (mic bracket not supplied) This bracket should
be supplied with CB. New mic bracket mounting holes may need to be drilled if
holes do not line up.
Step 5
Secure mic mounting plate using supplied 1 3/4” Phillips head screw.
Step 6
Mount CB to bracket and follow CB installation instructions for proper wiring
an operation.
Step 7
If CB mount makes contact with dash after CB has been mounted use supplied
foam pad. Pad should be attached between bracket and dash as shown.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE:
770-614-6101 | FAX:
770-614-6069 | info@omix-
ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>