Electrolux ECC6681G Cooker Hood User Manual

Electrolux ECC6681G Cooker Hood User Manual

WE’RE THINKING OF YOU

Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Welcome to Electrolux.

BEFORE USING YOUR APPLIANCE

Before you use the range hood, we recommend that you read through the whole user manual which provides the description of the range hood and its functions. To avoid the risks that are always present when you use an electrical appliance, it is important that the range hood is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards.
For future reference, please store this booklet in a safe place.

CONDITIONS OF USE

This appliance is intended to be used in household and similar applications such as

• Staff kitchen areas in shops, offices and other working environments
• Farm houses
• By clients in hotels, motels and other residential type environments
• Bed and breakfast type environments

BEFORE YOU CALL
Please ensure you read the instruction manual fully before you call for service, or a full service fee could be applicable.

RECORD MODEL AND SERIAL NUMBER HERE:
Model:
Serial NO:

LEGEND

WARNING!
This symbol indicates information concerning your personal safety

CAUTIONS!
This symbol indicates information on how to avoid damaging the range hood.

IMPORTANT!
This symbol indicates tips and information about use of the range hood.

ENVIRONMENT!
This symbol indicates tips and information about economical and ecological use of the range hood.

If at any time in future you need to dispose of this product please do Not dispose of this product with household waste, please send this product to collecting points where available
This product is RoHS compliant.

SAFETY INFORMATION

This manual explains the proper use of your new Electrolyte canopy range hood. Please read this manual carefully before using the product. This manual should be kept in a safe place for handy reference.
This range hood is a domestic appliance which has been manufactured and tested to comply with International Standard IEC 60335.2.31.

Read the following carefully to avoid damage or injury.

 This symbol indicates never to do this
 This symbol indicates always do this

WARNING! Follow these instructions carefully to avoid an electric shock or fire.

 Young children should be supervised to ensure they do not play with the rangehood.
 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance bya person responsible for their safety.
 Ensure the rangehood is switched off before carrying out maintenance, to avoid any possibility of electric shock.
 Never carry out flambe cooking under the rangehood.
 This rangehood is not recommended for barbecues.
 This rangehood cannot be installed for external use.
 Grease filters must be removed every four weeks (maximum) for cleaning to reduce the risk of fire.
The exhaust from the rangehood must not be discharged into any heating flue, which may carry combustion products from other sources .(Fig.1)
The exhaust air must not be discharged into a wall cavity, unless the cavity if designed for the purpose.
 There must be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels.
 Always cover lit gas burners with pots or pans when rangehood is in use.
 Always switch off gas burners before you remove pots or pans.
 Do not leave lit gas burners exposed due to the risk of fire. (Fig.2)

Electrical connection

Check that the mains voltage matches with the voltage on the data plate inside the rangehood. Check that the installation complies with standards of local building, gas and electrical authorities. Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the rangehood.lf the supply cord is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid a hazard.

Safety warnings For the installer

When installing the rangehood, make sure you adhere to the minimum and maximum distances from the range hood base to the hob surface (as per table on page 6).

Exhaust flue installation: The following rules must be strictly followed to obtain optimal air extraction.

• Keep exhaust flue short and straight
• Do not reduce the size or restrict exhaust flue.
• Keep bends in the exhaust flue to a minimum.
• When using flexible flue always install duct with helix pulled taut to minimise pressure loss.
• Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the range hood.

Exhaust air must not be discharged into a wall cavity, unless the cavity is designed for the purpose. The exhaust from the cooker hood must not be discharged into any heating flue, which may carry combustion products from other sources.

NOTE: Some installations may require the telescopic exhaust cover to be cut to length. Cut with sharp tin snips or a fine-tooth hack saw blade, taking are not to distort or dent the exhaust cover.

Product Description

ECC6681G
ECC9681G

Dimension

ECC6681G
ECC9681G

RANGE HOOD INSTALLATION

WARNING!
Refer to “Safety information” chapter

BEFORE INSTALLATION
Before the installation of the appliance, record the information below from the rating plate. The rating plate is on the bottom of the appliance casing.
Model
PNC
Serial number

1. Using a spirit level mark a vertical centre line on the wall where the cooker hood is to be positioned, and a horizontal line at the cooker hood base position (refer diagram below).
   NOTE. The height of the underside of the hood body must be a minimum of 650mm* to a maximum height of 800 mm
   If the instructions of the hob specify a greater distance than the minimum above, then that shall be the minimum height for installation.

2. Mark the location for cooker hood mounting points above the hood base as the reference point (Fig.5) .
   
   

WARNING!
Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

1. Install the wall bracket with screws to the wall as marked (Fig.6) .
   

2. Fit the flexible flue to the duct transition . Use fixing tapes to secure flexible pipe to the duct transition.
   NOTE: For ducted mode, we recommend extending flue pipe through the roof to external” roof cap” to vent exhaust externally. We do not recommend venting into ceiling cavity.

3. Hang the hood on the wall bracket (Fig.7)
   

4. Install two additional hood body mounting screws into the auxiliary mounting holes to secure the hood body in place .(Fig.8)
   

5. Electrical connection

   • Electrical wring must be done by a qualified person(s) in accordance with all applicable codes and standards. Turn off electrical power at service entrance before wiring.
   • If the power cord is damaged, it must be replaced by manufacturer, its agent or similarly qualified persons in order to avoid hazard.
   • Do not use the plug and an extension cord other than the ones initially supplied with the hoods.
   • The earthing of this hood is compulsory. Do not remove the ground prong of the plug.

Using The Range hood

Fan — select speed to suit cooking conditions

 Fan on/off
 light frying/boiling
2 frying/work cooking/heavy boiling
3 grilling, intensive frying and work cooking
 Self-clean
 Light

Self-clean instruction

This product is equipped with self-clean technology.
The self-clean function will be automatically triggered after the motor works for 15 hours.
User also can tap the self-clean button to trigger the self-clean function.
The red indicator will start glowing during the cleaning process.
The time period for Self-clean is 10 to 15 minutes. The product can be used during self-clean.
Your Electrolux range hood is now ready to use

MAINTENANCE AND CLEANING

CAUTION!

• Before maintenance or cleaning is carried out, the rangehood should be disconnected from the main power supply. Ensure that the rangehood is switched off at the wall socket and the plug removed if fitted.
• External surface are susceptible to scratches and abrasions, so please follow the cleaning instructions to ensure the best possible result is achieved without damage.
• These instructions must be followed to avoid a fire risk.

Control panel surface

The control panel can be cleaned using warm soapy water. Ensure the cloth is well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning.

Metal grease filter

1. Remove the grease filter by unscrewing 2pcs screws. This will disengage the filter from the hood. Tilt the filter downward and remove (Fig.11).
2. Wash the filter, taking care not to bend them. Allow them to be dry before refitting.
3. To install the grease filter, push filter into position and release. Re screw two screws .Make sure the filter is securely engaged after assembly.
   

Replacing lamps (Fig.12)

1. Extract the guard by levering it off with a small screwdriver or similar tools.
2. Replace the damaged LED, only use. LED DC12V,2W Max.
   

WARNING:

1. Always switch off the electrical supply before carrying out any operation on the appliance.
2. Only a qualified and trained service technician can undertake the work of bulbs replacement and servicing.

NOTE: We recommend only using lamps of the same specification as the ones being replaced.

Changing the lamp

Lamps are long life LED lamps and should not require service. If there is an issue with lamp please contact the Service Center.

Troubleshooting

electrical supply Check that a fan speed has been selected
The Range hood is not working| Check that the fan speed is set high enough for the task The grease filters are clean
The kitchen is adequately vented to allow the entry of fresh air
If set up for re circulation, check that the charcoal filter is still effective
If set up for extraction, check that the duct and outlets are not blocked
Do not operate cook top without pots/pans Do not flambe under cook top
The range hood has switched off during operation| If the hood has been installed below the heights indicated in the installation instructions the motor will cut out frequently which will damage the hood

If you have completed all the above checks and are still experiencing difficulty, please contact your local Electrolyte Service Center.
Note: This product is fitted with a safety cutout device.

• If the range hood is installed too close to the cooker top, flambe cooking, operating the cook top without cooking utensils and blocked filters may activate the safety cutout device. If the hood stops during operation, correct the faults and allow time for the safety cutout device to reset. Then the range hood will function correctly.
• Do not operate cook top without pots/pans
• Do not flambe under cook top

Consumer Care Center

Philippines
Consumer Care Center Toll Free:
1-800-10-845-CARE(2273)
Consumer Care Hotline:(+63 2)845-CARE(2273)
Electrolux Philippines,lnc.
Unit B 12F Cyber Sigma Bldg, Lawton Avenue,
McKinley West,Taguig, Philippines 1634
Trunk line: +63 2 737-4757
Website:www.electrolux.com.ph
Email: wecare@electrolux.com

Vietnam
Consumer Care Center Toll Free
1800-58-88-99
Tel: (+84 28) 39105465
Electrolux Vietnam Ltd.
Unit 1&2, 10F Sofic Tower, #10 Mai Chi Tho
Street,
Thu Thiem Ward, Thu Duc City, Ho Chi
Minh City, Vietnam

References

• Electrolux Philippines | All Home Electrical appliances & Kitchen appliances

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>