PDP 500-234 Wireless Controller User Guide
- June 13, 2024
- PDP
Table of Contents
EALMz™ Wireless Controller
Quick Start Guide
For:
Nintendo Switch
Nintendo Switch – OLED Model
Nintendo Switch is a trademark of Nintendo. © 2023 Nintendo
500-234 Wireless Controller
NOTICE: Before using the controller, we recommend fully charging it as it will only have an hour or two of battery life out of the box.
Pairing the Controller
A. Turn on your Nintendo Switch™ device and press any button on the
controller.
B. If your controller does not automatically connect, it will need to be
paired with the device.
C. Using the Joy-Con™ controllers, navigate to Controllers > Change
Grip/Order.
D. Now, using your controller, press and hold the sync button (at the top of
the controller by the charging port) for 3 seconds until it pairs and the
player indicator light at the bottom is solid.
Tip: To unpair the controller from the Nintendo Switch, hold down the
sync button (located at the top of the controller) for at least 1 second.
Re-connecting the Controller
A. If the controller is not connecting with the device, but has already been
paired, simply go into Controllers > Change Grip/Order.
B. When prompted, press L and R on your controller to connect.
Tip: You can also press and hold the “Home” button to wake up the
controller and Nintendo Switch™ device.
Charging the Controller
A. When the controller is low on battery, the “function” button’s LED (located
at the center of the controller between the + and – buttons) will blink RED
every 30 seconds.
B. Using the included USB-C cable, connect the controller to one of the USB
ports on the Nintendo Switch dock.
C. While charging, the “function” button’s LED will pulse RED. When the
controller is fully charged, the LED will turn WHITE.
Note: To prevent the controller battery from completely draining out,
please charge the controller every 3 months even if it’s not in use.
D. The REALMz Wireless Controller comes with a 1 ft. USB-C charging cable. To
play while charging, longer USB-C cables are available for purchase on
pdp.com.
Change LED Lighting Modes
A. The REALMz™ Wireless Controller comes with four different lighting effects
pre-programmed to the controller’s A, B, X, and Y buttons.
B. To explore these effects and cycle through them, hold the “function” button
and press either A, B, X, or Y.
C. The REALMz Wireless Controller also comes with a “Collector Mode” light
setting that allows you to keep the controller’s LEDs lit while the controller
is connected to the Nintendo Switch dock via a USB-C cable. To enable these
settings, follow the instructions below:
a. Plug the USB side of the cable into the Nintendo Switch dock. Then, while
the controller is unplugged, hold the “function” button and D-pad right, and
plug in the USB-C cable into the controller.
D. To keep the controller paired and lit for extended periods of time, you can
disable the auto-sleep settings on the Nintendo Switch. On your device,
navigate to System Settings > Sleep Mode > Auto Sleep (Connected to TV) >
select “Never.”
Note: When the controller and system turn off, the lighting modes reset
to the default mode (the mode for the A button).
Adjusting LED Light Settings
A. To adjust the LED brightness, hold the “function” button and press either ZL or the D-pad down button to decrease brightness, or either ZR or the D-pad up button to increase brightness.
WARNING: DO NOT DISASSEMBLE THE CONTROLLER!
Disassembling the controller to remove the figurine or any other components
will void the 2-year manufacturer’s warranty. The figurine is securely fixed
inside the controller and is not designed for removal by users.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>