duraflame DFS-7515 Series Electric Fireplace Stove Heater Instruction Manual

duraflame DFS-7515 Series Electric Fireplace Stove Heater

Product Information

• Model: DFS-7515-01, DFS-7515-02, DFS-7515-03, DFS-7515-04, DFS-7515-05, DFS-7515-06
• Website: www.tsicustomerservice.com
• Customer Service: 1-888-674-7517
• Serial Number: A486
• Website for Manual: https://manual-hub.com/

Product Specifications:

• Voltage: 120VAC
• Amps: 12.5 Amps
• Watts (max.): 1500 Watts
• Frequency: 60 Hz

Product Usage Instructions

Getting Started

1. Locate the serial number on the back of the Fire Cube. This number is necessary for product warranty registration and customer service.
2. To register for product warranty, visit www.tsicustomerservice.com.
3. Use the model number DFS-7515-01, DFS-7515-02, DFS-7515-03, DFS-7515-04, DFS-7515-05, or DFS-7515-06. If unable to register, keep the proof of purchase for warranty purposes.

Operation Instructions

Control Panel Location:
The control panel is located on the Fire Cube.

Main Power Switch:
The main power switch supplies power to all functions of the Fire Cube, including the flame effect and heater. Make sure the main power switch is turned on for the heat to be used.

Heater Settings:

• Make sure the main power switch is in the ON position to use the heater.
• 0: Heater off
• 750W: Low heat setting, 750 Watts
• 1500W: High heat setting, 1500 Watts

Bulb Replacement

Tools Required for Assembly:
Phillips Head Screwdriver

Light Bulb Type:
Clear, 40-watt, Z12 socket base light bulb (candelabra base, B bulb)

1. Remove the Phillips head screws.
2. Remove the back panel to access the light bulb.
3. Pinch the spring clip to loosen and gently unscrew the old bulb.
4. Replace with a new 40w candelabra bulb.

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons including the following:

1. Read all instructions before using this appliance.
2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this appliance. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of this appliance. WARNING: In order to avoid overheating, do not cover the heater.
3. CAUTION: Never leave the heater operating unattended. Extreme caution is necessary if unsupervised children or invalids are nearby.
4. The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction.
5. Children being supervised not to play with the appliance.
6. If possible, always unplug this appliance when not in use.
7. Do not operate any heater with a damaged cord or plug or after the appliance malfunctions, or if it has been dropped or damaged in any manner.
8. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
9. Any repairs to this fireplace should be carried out by a qualified service person.
10. Under no circumstance should this fireplace be modified. Parts having to be removed for servicing must be replaced prior to operating this fireplace again.
11. Do not use outdoors.
12. This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate this appliance where it may fall into a bathtub or other water container.
13. Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners or the like. Arrange the cord away from traffic areas and where it will not be tripped over.
14. To disconnect this appliance, turn the controls to the off position, then remove the plug from the outlet.
15. Connect to properly grounded outlets only.
16. This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.2 Canadian Electrical Code or for U.S.A. installations, follow local codes and the National Electrical Code, ANSI/NFPA NO.70.
17. There is a thermostat limiter inside the heater. When the inner temperature overheats or abnormal heating occurs, the thermostat protective device cuts off the power supply to prevent damage or risk of fire.
18. The heaters must not be located immediately below a socket outlet.
19. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the appliance.
20. To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on soft surfaces, like a bed, where the opening may become blocked.
21. This appliance has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored. This fireplace should not be used as a drying rack for clothing. Christmas stockings or decorations should not be hung in the area of it.
22. Use this appliance only as described in the manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.
23. Always plug heaters directly into a wall outlet/ receptacle. This heater is for use on 120 volts. Never use with an extension cord or relocatable power tap(power strip).
24. This heater is for use on 120 volts. This product is equipped with a polarized plug (one blade is wider than the other blade). To reduce the risk of electrical shock, this plug will fit into a polarized outlet only one way. This is a safety feature. If you are unable to insert the plug into the electrical outlet, try reversing the plug. If the plug still does not fit, contact a qualified electrician.

SAVE THESE INSTRUCTIONS

GETTING STARTED

1. The serial number is located on the back of the Fire Cube, the serial number is necessary for product warranty registration and customer service
2. Go to www.tsicustomerservice.com for product warranty registration. For registration use the MODEL NUMBER: DFS-7515-01, DFS-7515-02, DFS-7515-03,DFS-7515-04,DFS-7515-05,DFS-7515-05. If you are unable to complete registration save your proof of purchase for warranty purposes

PRODUCT SPECIFICATIONS

CARE AND MAINTENANCE

Clearance To Combustibles
Keep electrical cords, drapery, furniture and other combustibles at least 3 ft (0.9 m) from the front of the heater and away from the sides.

Cleaning Trim
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil- based product and buff with a soft, clean cloth. DO NOT use brass polish or household cleaners as these products will damage the metal trim. Purchase citrus oil-based products at a hardware store.

**OPERATION INSTRUCTIONS

**

BULB REPLACEMENT

Tools Required for Assembly

1. Remove the Phillips head screws
2. Remove back panel to access light bulb
3. Pinch this spring clip to loosen. Gently turn and pull the rubber grommet of the motor shaft.
4. Pull away the bulb retaining spring, unscrew the old bulb, and replace with a new 40w candelabra bulb

TROUBLESHOOTING GUIDE

the outlet.

| 1.     Check that unit is plugged directly into a standard 120 volt outlet.
2. Fire Cube does not turn on manually.| 2a.

2b.

| No incoming power from the electrical wall socket or switches. Improper operation.| 2a. Check circuit breakers and move unit to another outlet. 2b. Manually press main power button from back of unit.
3. Flames are not moving| 3. Flame Generator/Spinner detached from the Flame Generator Drive Motor| 3.     Unplug the Fire Cube and remove the back panel and check to see if “Flame Generator/Spinner” is correctly mounted to the Flame Generator Drive Motor.
4. Flames are not visible| 4.     Burnt out light bulb.| 4.     Follow bulb replacement instructions to replace the light bulb.
5. Heater is not turning on| 5.     Improper operation| 5.     Manually press main power button on back of unit.
6. Not producing enough heat| 6a.

6b.

| power strip/surge protector/ extension cord being used Location of unit| 6a. Plug unit directly into the wall.

6b. Make sure unit is located on an interior wall or away from drafty doors or windows.

7. Excessive noise with the heater on| 7.     Dirty heater blower motor| 7. Gently vacuum heater blower vents.
8. Noise with flames on and heater off| 8a.

8b.

| Dented back panel Warped Flame Generator/ Spinner shaft| 8a. Contact customer service 8b. Contact customer service
9. Power cord gets

warm

| 9. Normal operation| 9.     Check your heater cord and plug connections. Faulty wall outlet connections or loose plugs can cause the outlet or plug to overheat. Be sure the plug fits tight in the outlet. Heaters draw more current than small appliances, overheating of the outlet may occur even if it has not occurred with the use of other appliances. During use check frequently to determine if your plug outlet or faceplate

is HOT! If so, discontinue use of the heater and have a qualified electrician check and/or replace the faulty outlet(s).

10. Is it safe to place unit on carpet?| 10. Product inquiry| 10. It is safe to place unit on carpet but make sure any flammable

items are at least 3 feet (0.9 m) away from front and sides of the unit.

11. How many square feet will my unit warm up?| 11. Product inquiry| 11. Provides supplemental heat up to 400 square feet
12.Heater doesn’t work, but Power and Heaters witches

are in the “ON” position and

thermostat is set on the highest level.

| 12. The thermal protector has tripped.| 12. Turn all switches to the “OFF” position and unplug the unit from the wall outlet for 5 minutes. After 5 minutes, plug the unit back into wall outlet and operate as normal.

Note , the scale and size of your parts may be different depending on your exact model.

EXPLODED VIEW

Part                                 Part Name Part Number

1| Power Switch| P06-S
2| Heater Switch – 750W/1500W| Y16-S204-P06
3| Ember bed| Y17-S238-P02
4| Heater/Blower Assembly| Y16-S204-P01
5| Flame Generator Drive Motor| P10-Q-S

WARRANTY

1-YEAR LIMITED WARRANTY

The manufacturer warrants that your new Electric stove is free from manufacturing and material defects for a period of one year from date of puchase, subject to the following conditions and limitations.

1. Install and operate this appliance in accordance with the installation and operating instructions furnished with the product at all times. Any unauthorized repair, alteration, willful abuse, accident, or misuse of the product shall nullify this warranty.
2. This warranty is non-transferable, and is made to the original owner, provided that the purchase was made through an authorized supplier of the product.
3. The warranty is limited to the repair or replacement of part(s) found to be defective in material or workmanship, provided that such part(s) have been subjected to normal conditions of use and service, after said defect is confirmed by the manufacturer’s inspection.
4. The manufacturer may, at its discretion, fully discharge all obligations with respect to this warranty by refunding the wholesale price of the defective part(s).
5. Any installation, labor, construction, transportation, or other related costs/expenses arising from defective part(s), repair, replacement, or otherwise of same, will not be covered by this warranty, nor shall the manufacturer assume responsibility for same.
6. The owner/user assumes all other risks, if any, including the risk of any direct, indirect or consequential loss or damage arising out of the use, or inability to use the product,except as provided by law.
7. All other warranties – expressed or implied –with respect to the product, its components and accessories, or any obligations/liabilities on the part of the manufacturer are hereby expressly excluded.
8. The manufacturer neither assumes, nor authorizes any third party to assume on its behalf, any other liabilities with respect to the sale of the product.
9. The warranties as outlined within this document do not apply to nonaccessories used in conjunction with the installation of this product.
10. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

This warranty is void if:

• The stove is subjected to prolonged periods of dampness or condensation.
• Any unauthorized alteration, willful abuse, accident, or misuse of the product.
• You do not have the original receipt of purchase.

CUSTOMER SERVICE

www.tsicustomerservice.com
For Customer Service Call 1-888-674-7517
Questions? Our message centers are available 7 days a week 24 hours a day at our toll-free help line. Our Consumer Service department is available Monday – Friday 8:30 am – 5:30 pm EST. We can help you with assembly and if necessary, replace damaged/missing parts.

IMPORTANT:
Before contacting Customer Service please have this information available:

• Serial Number
• Model Number
• Sales Receipt or Proof of Purchase

www.tsicustomerservice.com

MODEL:
DFS-7515-01, DFS-7515-02, DFS-7515-03 DFS-7515-04, DFS-7515-05, DFS-7515-06

References

• CSR Login Page
• Home - Twin Star InternationalTwin Star International
• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>