tommee tippee 423645 Wearable Pump Milk Collectors Instructions

tommee tippee 423645 Wearable Pump Milk Collectors

FEATURES

USE INSTRUCTION

WARNING!

• Always use this product with adult supervision. Accidents have occurred when babies have been left alone with drinking equipment due to the baby falling or if the product has disassembled.
• Never use feeding teats as a soother.
• Continuous and prolonged sucking of fluids will cause tooth decay. Tooth decay in young children can occur even when non-sweetened fluids are used. This can occur if the baby is allowed to use the bottle for long periods through the day and particularly through the night, when saliva flow is reduced or if it is used as a soother.
• Always check food temperature before feeding. Heating in a microwave oven may produce localised high temperatures. Take extra care when microwave heating. Always stir heated food to ensure even heat distribution and test the temperature before serving.
• Throw away at the first signs of damage or weakness.
• Keep components not in use out of the reach of children.
• Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
• The bottle hood can pose a suffocation hazard – keep out of the reach of children

CLEANING

Before first use, clean the product. Clean before each use. Always wash the product immediately after use. Wash in warm soapy water and rinse in clean water or use a dishwasher (top shelf only). Do not clean with solvents or harsh chemicals. Do not allow product to come into contact with oil based foods (e.g. oil/tomato based sauces) as staining will occur. Do not turn the teat inside out for cleaning. Damage could result. Use a teat brush.

TAKE EXTRA CARE when cleaning the sensitive anti-colic teat valve. In order to ensure optimum venting the teat valve is manufactured using a thinner silicone than the teat itself and therefore care needs to be taken during cleaning to ensure no damage is caused.
DO NOT USE A TEAT BRUSH or any other implement to clean the anti-colic valve and/or the feeding hole as damage such as splits and tears may occur. However, performance of the teat may be affected if the anti-colic valve is not cleaned thoroughly after each use. Ensure valve is flushed with warm water during cleaning.

STERILISING

Before first use place in boiling water for 5 minutes. This is to ensure hygiene.
Suitable for all forms of sterilisation by steam (electric or microwave), boiling or cold water tablet/ liquid solution.

1. After each use disassemble all parts of the bottle.
2. Wash thoroughly with hot soapy water.
3. Rinse all components using fresh water.
4. After rinsing, re-assemble the teat and screw ring.
5. Place all components including the teat and screw ring assembly in the steriliser. After sterilisation the teat can then be picked up using the screw ring and used as normal.

ASSEMBLY OF YOUR TEAT AND SCREW RING

a. Due to the larger size of Tommee Tippee’s new teat and screw ring, care needs to be taken during assembly to ensure that the teat is in the correct position shown (diagram a).
b. The best method of assembly of the teat and screw ring is to carefully pull the teat through the ring in different directions to ensure the silicone lip fully ‘clips’ over the edge of the screw ring. The area where the teat and screw ring meet should be flush as shown (diagram b). Though you may find this tricky at first, you will quickly develop a technique and find it as easy as a conventional teat and screw ring.

STORAGE AND USE

Inspect before each use and pull the feeding teat in all directions. Do not store or leave in direct sunlight or near a source of heat. Do not store with or allow to come into contact with solvents or harsh chemicals. Not suitable for use in a conventional oven or a combination microwave oven with the grill feature switched on. Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant (“sterilising solution”) for longer than recommended, as this may weaken the teat. For safety and hygiene reasons it is recommended the a feeding teat is replaced at least every 2 months. Do not heat in a microwave with bottle sealed. Remove teat, locking ring and bottle hood.

Customer Service

Mayborn (UK) Limited
Balliol Business Park, Newcastle upon Tyne, NE12 8EW, UK
EU Representative
Mayborn France Sarl, 56 Rue de Paris,
Boulogne Billancourt, 92100, France
TOMMEE TIPPEE®. MADE FOR ME®. Copyright 2022.
All IP rights held by Mayborn (UK) Limited and/or its affliates.
Patented; https://www.tommeetippee.com/en-us/legals/patent,EP1863427 AND EP1765257.
Mayborn USA Inc.
11th Floor, 1010 Washington Boulevard, Stamford,
Connecticut 06901.
423645

References

• Simple & Intuitive Baby Products | Tommee Tippee
• Virtual Patent Marking and Legals | Tommee Tippee US

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>