METROPOLITAN N6662-865 Amesbury 1-Light Black and Aged Brass Shaded Pendant Light Installation Guide

METROPOLITAN N6662-865 Amesbury 1-Light Black and Aged Brass Shaded

Pendant Light

Product Information

• Product Model: N6662-865
• Product Name: Fixture
• Manufacturer: Unknown

Product Usage Instructions

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. READ AND SAVE THESE INSTRUCTIONS

Preparation

1. Shut off the power at the fuse box or circuit breaker box. If necessary, remove the old fixture and all mounting hardware from the junction box.

2. Carefully unpack the new fixture and lay out all the parts on a clear area. Take care not to lose any parts necessary for installation.
   Assembling the Fixture: (Fig.1)

3. Place the outer glass shade (Q), cap (O), tube (N), and decorative round ball (M) over the thread (P), then secure with the coupling (L).

4. Place the inner glass shade (S) and metal washer (T) over the socket (R), then secure with the socket cup (U).

5. Determine the desired hanging height and thread the rods (H, I, J, K) to the coupling (L). Then thread the swivel (G) of the canopy
   (E) onto the rod (H).

6. Pass wires carefully through each rod, swivel (G), and canopy (E).
   Mounting the Fixture: (Fig.1)
   

7. Thread two mounting screws (A) (Size: #8-321.4″L) into crossbar (B) spaced same distance apart as holes in canopy (E). Length of mounting screws (A) into crossbar (B) may be adjusted if necessary. Attach crossbar (B) to junction box (Not included) using junction box screws (C) (Size: #8-320.6”). The side of crossbar (B) marked “GND” must face out.

8. The support cable is provided to support weight of fixture while wiring. Attach hook (D) onto end of support cable to crossbar (B). Carefully allow support cable to support the weight of fixture while wiring.
   Connecting the Wires: (Fig.2)

9. Connect the electrical wires as shown in figure 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect ground wires to it. Otherwise, connect the ground wire directly to the crossbar (B) and secure using the green screw provided.

10. Tuck wire connectors neatly into the junction box.
    Completing the Installation: (Fig.2)
    Raise canopy (E) over mounting screws (A) and secure with cap nuts (F).

11. Install (1) one medium base bulbs up to 100 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification. (DO NOT EXCEED THE SPECIFIED WATTAGE!)

Final Steps:
Your installation is now complete. Return power to the junction box and test the fixture. Your installation is now complete. Return power to the junction box and test the fixture.

Instructions

a. Hardware Bag:

• A. Mounting Screws *2
• B. Crossbar *1
• C. Junction Box Screws *2
• E. Canopy *1
• F. Cap Nuts *2

b. Hardware Bag:

• I, J, K. Rod 12’’ *3
• H Rod 6” *1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>