Metropolitan N7541-729 One Light Mini Pendant Instruction Manual
- October 30, 2023
- Metropolitan
Table of Contents
INSTALLATION INSTRUCTIONS
Item #N7541-729 (07/07/2022)
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
PREPARING THE FIXTURE (Fig.2)
-
Carefully unpack the new fixture and lay out all the parts on a clear area. Take care not to lose any parts necessary for installation.
-
Shut off the power at the fuse box or circuit breaker. If necessary, remove the old fixture, including the mounting hardware.
-
By measuring determine desired hanging height and thread rods (B & F) into top all thread of fixture body.
-
Carefully pass fixture wires through each rod as you assemble.
-
Pass the wires through canopy (C) and pull until tight. Then thread canopy onto top of rods.
MOUNTING THE FIXTURE (Fig.1) -
The mounting strap contains several pairs of threaded holes, find the pair of holes that match holes spacing in your fixture canopy and thread two fixture screws into mounting strap and tighten with hex nut. Note: The length of fixture screw into mounting strap may be adjusted if necessary.
-
Attach mounting strap to outlet box (not included) using box screws (Size: #8-32*0.5L). The side of mounting strap marked “GND” must face out.
-
The support cable is provided to support the weight of fixture while wiring. Align fixture to mounting strap and attach hook on the end of support cable into a slot located on mounting strap. Carefully allow support cable to support the weight of fixture while wiring.
CONNECTING THE WIRES (Fig. 3) -
At this point, connect the electrical wires as shown in Fig. 3, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect
the fixture’s ground wire directly to the mounting strap using the green screw provided. -
Tuck wire connectors neatly into outlet box.
FINISHING THE INSTALLATION (Fig.1 & 2) -
Place fixture canopy (C) over two fixture screws (or all thread) and secure with decorative nuts.
-
Install glass (D) to arm and secure with screws and plastic washers provided.
-
Fasten small arm (E) to inside of the frame and secure with screws.
-
Fasten large arm (A) to outside of the frame and secure with screws.
-
Install (1) one medium base bulbs up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to theoutlet box and test the
fixture.
Note: Illustration on this manual is for installationpurposes only. It
may or may not be identical to thefixture purchased. Do not clean your light
fixture orparts with water or cleanser. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>