METROPOLITAN N7843-711 Brookcrest 20 Inch 4-Light Sand Coal and Gold Leaf Semi-Flush Mount Instruction Manual

October 30, 2023
Metropolitan

METROPOLITAN logo INSTALLATION INSTRUCTIONS
Item #N7843-711 (04/20/2022)
READ AND SAVE THESE INSTRUCTIONS

N7843-711 Brookcrest 20 Inch 4-Light Sand Coal and Gold Leaf Semi-Flush

Mount

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

PREPARING THE FIXTURE (Fig.2)

  1. Carefully unpack the new fixture and lay out all the parts on a clear area. Take care not to lose any parts necessary for installation.

  2. Thread rods (B) into the top nipple of the fixture body.

  3. Pass the wires through the canopy (C) and pull tight. Then thread the canopy onto the rod.
    MOUNTING THE FIXTURE (Fig.1)
    METROPOLITAN N7843-711 Brookcrest 20 Inch 4-Light Sand Coal and Gold Leaf
Semi-Flush Mount - fig 1

  4. Shut off the power at the fuse box or circuit breaker. If necessary, remove the old fixture, including the mounting hardware.

  5. The mounting strap contains several pairs of threaded holes, find the pair of holes that match the holes spacing in your fixture canopy and thread the two fixture screws 1/4 into the fixture mounting strap.

  6. Attach mounting strap to the outlet box using the box screws (Size: #8-32*0.5L). The side of the mounting strap marked “GND” must face out.

  7. Hook the hook of supporting cable to the mounting strap.
    CONNECTING THE WIRES (Fig. 3)

  8. At this point, connect the electrical wires as shown in Fig. 3, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting strap using the green screw provided. After the wires are connected, tuck them carefully inside the outlet box.
    FINISHING THE INSTALLATION (Fig.1 & 2)
    METROPOLITAN N7843-711 Brookcrest 20 Inch 4-Light Sand Coal and Gold Leaf
Semi-Flush Mount - fig 2

  9. Place fixture canopy (C) over two fixture screws (or nipple) and secure with decorative nuts.

  10. Place candle cover (A) on the socket.

  11. Install (4) four candelabra base bulbs up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
    METROPOLITAN N7843-711 Brookcrest 20 Inch 4-Light Sand Coal and Gold Leaf
Semi-Flush Mount - fig 3

Your installation is now complete. Return power to the outlet box and test the fixture.
Note: Illustration on this manual is for installation purposes only. It may or may not be identical to the fixture purchased. Do not clean your light fixture or parts with water or cleanser.

METROPOLITAN logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Metropolitan User Manuals

Related Manuals