Brook P5 Mini Fighting Board User Guide
- June 13, 2024
- Brook
Table of Contents
Brook P5 Mini Fighting Board
Firmware Update Guide – P5 mini Fighting Board
This document provides instructions on how to update the firmware of the
Brook P5 mini Fighting Board.
Product Information
- Product Name: P5 mini Fighting Board
- Manufacturer: Brook
Important Notes:
- The firmware update can only be performed on a PC and cannot be done on a console.
- Ensure that your PC is connected to the internet.
- If you encounter any issues during the update process, you may try disabling your antivirus software or running the program as an administrator.
Product Usage Instructions
- Step 1: Download the update file from the official Brook website: www.brookaccessory.com
- Step 2: Press and hold down the PS and Share/Select buttons simultaneously. While holding these buttons, connect the USB cable to your computer.
- Step 3: When the START icon appears, click on the icon to start the firmware update.
- Step 4: Do not disconnect the USB cable during the update process.
- Step 5: The following screen will be displayed when the update has successfully finished.
- Step 6: In case the firmware update fails, the following screen will be displayed. Please redo the setup from the beginning. We recommend visiting our website www.brookaccessory.com and downloading the update file again before restarting the update process.
INSTRUCTION
This document describes how to update the firmware of Brook P5 mini Fighting Board.
NOTE
- The update must be done on a PC; it cannot be done on a console.
- Make sure your PC is connected to the internet.
- You may try to disable antivirus, or run the program as administrator.
STEP 1 Download the update file from “Download” on Brook website: www.brookaccessory.com
STEP 2 Press and Hold down PS and Share /Select at same time. While pressing these buttons,connect the USB to the computer.
STEP 3 When START icon shows up, click the icon to start update.
STEP 4 DO NOT disconnect during the update process
STEP 5 The following screen will be shown when the update has successfully finished.
STEP 6 In case firmware update fails, the following screen will show, and
please try to redo the setup from the beginning.
We recommend that you visit our website www.brookaccessory.com and download
the update file again before restarting the update.
© Brook All Rights Reserved. www.brookaccessory.com October 2023
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>