Radiolink RC4GS V3 5 Channels RC Transmitter User Manual

Radiolink RC4GS V3 5 Channels RC Transmitter

Product Information

• Manufacturer: Global United Technology Services Co., Ltd.
• Verification No.: GTSL202109000128EV1
• Applicant: Radiolink Electronic Limited
• Address of Applicant: 3/F, Building 2, Fuguo industrial park, Kaifeng Road, Meilin, Shenzhen, Guangdong China
• Product Name: Radio Control
• Model No.: RC6GS, RC4GS, RC4GS V2 with R6FG Receiver, RC6GS V2 with R7FG Receiver
• Trade Mark: Radiolink

The radio equipment meets the following essential requirements:

• Article 3.1 a): Health and Safety – Conform
• Article 3.1 b): Electromagnetic Compatibility – Conform
• Article 3.2: Effective and Efficient Use of Radio Spectrum – Conform

Additional Essential Requirements

Note

1. The verification is only valid for the equipment and configuration described, in conjunction with the test reports detailed below. The product is in conformity with the essential requirements of Article 3.1 (a) the protection of health, 3.1 (b) an adequate level of electromagnetic compatibility and 3.2 effective use of the spectrum of 2014/53/EU.
2. The CE mark as shown above can be used, under the responsibility of the manufacturer, after completion of an EC Declaration of Conformity and compliance with all relevant EC Directives. The affixing of the CE marking presumes in addition that the conditions in all relative Directive are fulfilled.
3. Copyright of this verification is owned by Global United Technology Services Co., Ltd. and may not be reproduced other than in full and with the prior approval of the General Manager. This verification is subjected to the governance of the General Conditions of Services, printed overleaf.

Product Usage Instructions

To use the Radio Control product (Model No.: RC6GS, RC4GS, RC4GS V2 with R6FG Receiver, RC6GS V2 with R7FG Receiver) manufactured by Radiolink, follow these instructions:

1. Ensure that the product is powered on and functioning properly.
2. Read and understand the user manual provided with the product for detailed instructions on its operation.
3. Make sure to comply with the health and safety guidelines mentioned in the user manual to ensure personal safety while using the product.
4. Ensure that the product is used in an environment where electromagnetic compatibility is maintained to avoid interference with other devices.
5. Follow the instructions provided in the user manual for effective and efficient use of the radio spectrum.
6. If any issues or concerns arise during the usage of the product, refer to the troubleshooting section of the user manual or contact Radiolink Electronic Limited for assistance.

Verification of Compliance

• Verification No.: GTSL202109000128EV1
• Applicant: Radiolink Electronic Limited
• Address of Applicant: 3/F,Building 2, Fuguo industrial park, Kaifeng Road, Meilin, Shenzhen, Guangdong China
• Product Name: Radio Control
• Model No.: RC6GS, RC4GS, RC4GS V2 with R6FG Receiver, RC6GS V2 with R7FG Receiver
• Trade Mark:  Radiolink

The radio equipment meets the following essential requirements:

• Article 3.1 a): Health and Safety: Conform
• Article 3.1 b): Electromagnetic Compatibility: Conform
• Article 3.2: Effective and Efficient Use of Radio Spectrum: Conform
• Additional Essential Requirements: Not applicable

Note

1. The verification is only valid for the equipment and configuration described, in conjunction withthe test reports detailed below. The product is in conformity with the essential requirements ofArticle 3.1 (a) the protection of the health, 3.1 (b) an adequate level of electromagneticcompatibility and 3.2 effective use of the spectrum of 2014/53/EU.
2. The CE mark as shown above can be used, under the responsibility of the manufacturer, aftercompletion of an EC Declaration of Conformity and compliance with all relevant EC Directives.The affixing of the CE marking presumes in addition that the conditions in all relative Directive arefulfilled.
3. Copyright of this verification is owned by Global United Technology Services Co., Ltd. and maynot be reproduced other than in full and with the prior approval of the General Manager. Thisverification is subjected to the governance of the General Conditions of Services, printed overleaf.

Annex

Sufficient samples of the product have been tested and found to be in conformity with:

Applicable standards/ Test report number:

• Article 3.1 a): EN 62479:2010/ GTSL202109000128E03
• Health and Safety: EN 62368-1:2014/A11:2017 /GTSL202109000128S01
• Article 3.1 b): Electromagnetic Compatibility
  • ETSI EN 301 489-1 V2.2.3 (2019-11)/ GTSL202109000128E01
  • ETSI EN 301 489-17 V3.2.4 (2020-09)
• Article 3.2: Effective and Efficient Use of Radio Spectrum
  • ETSI EN 300 328 V2.2.2 (2019-07)/ GTSL202109000128E02

Contact

• Address: No. 123-128, Tower A, Jinyuan Business Building, No.2, Laodong Industrial Zone, Xixiang Road, Baoan District, Shenzhen, Guangdong, China 518102
• Telephone: +86 (0) 755 2779 8480,
• Fax: +86 (0) 755 2779 8960,
• Website: www.gtstest.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>