RadioLink A560 3D RC Airplane Instruction Manual

October 30, 2023
RADioLink

RadioLink A560 3D RC Airplane

RadioLink A560 3D RC Airplane

Assembly & Disassembly Instruction

All electronic components of A560 are already set. If it’s the RTF version(with transmitter T8S and receiver packed), all you need to do after unpacking the box is to assemble the wing and tail (horizontal stabilizer), which is easy and fast.
Note: If it is the PNP version(without transmitter T8S or receiver packed), please follow the instruction manual of A560 to set channel 5 and channel 7 in your transmitter.

A560 Introduction

RadioLink A560 3D RC Airplane 1

RadioLink A560 3D RC Airplane 2

A560 Spare Part List

RadioLink A560 3D RC Airplane 3

A560 Assembly Steps

Install the wing

RadioLink A560 3D RC Airplane 4

Install the tail (horizontal stabilizer)

RadioLink A560 3D RC Airplane 5

Connect tail support rods

RadioLink A560 3D RC Airplane 6

Connect aileron and tail drawbars

RadioLink A560 3D RC Airplane 7

Install the landing gear
Install the propeller

RadioLink A560 3D RC Airplane 8

Please scan the code to view A560 tutorials

RadioLink A560 3D RC Airplane 9

A560 Disassembly Steps

After the flight, please disconnect the battery first, and then refer to the above assembly steps to disassemble the parts of A560 in turn. The disassembly steps
are as follows:

  1. Disassemble the propeller.
  2. Disassemble the landing gear. Please see Note①
  3. Disassemble the the drawbars and support rods. Please see Note②
  4. Diassemble the buttons to fix the wing. Remove the slotted fuselage vane and wing. Insert the slotted fuselage vane back.
  5. Diassemble the button to fix the tail. Remove the two parts of the tail (horizontal stabilizer).
  6. Arrange all the spare parts and put them into the bag in turn. Keep all drawbars and support rods parallel to the fuselage when packing the fuselage in the bag.
    Please see Note③

Disassembly Notes

  1. When disassembling the landing gear, please push the two metal rods of the landing gear in opposite directions at the same time, and then push the metal rods to make it out of the slot.
  2. When disassembling the drawbars or support rods, please put the screwdriver in the middle gap of the clasp, and then pry it.
  3. When packing the fuselage in the bag, please keep all drawbars and support rods parallel to the fuselage to avoid damage to the drawbar/rod caused by improper placement.

RadioLink A560 3D RC Airplane 10

Packing Steps

After the disassembly, please pack the parts of the A560 in the bag as shown in the picture below.

RadioLink A560 3D RC Airplane 11

T8S Transmitter Setup

Phase Setup:Set the direction of channel 3 to Reverse, and other channels to Normal.
Flight Mode Switch:There are six flight modes in A560. Flight modes are set by CH5(3-way switch SWB) and CH7(3-way switch SWA) as below:

RadioLink A560 3D RC Airplane 12

www.radiolink.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals