AM PM LIKE W80S-100PS-150MT Shower Door Installation Guide
- August 3, 2024
- AM PM LIKE
Table of Contents
AM PM LIKE W80S-100PS-150MT Shower Door
Product Information
Specifications
- Model: WMA-W80S-100PS-150MT
- Language: Deutsch, English
- Manufacturer: AM.PM Europe GmbH
- Website: www.ampm-world.com
Product Usage Instructions
- Attach the wall profile (wandprofil) using the provided dowels and screws.
- Install the glass frame (glasrahmen) onto the wall profile.
- Place the vertical seal (dichtung vertical) between the glass frame and the wall profile.
- Secure the profile cover (profilabdeckung) over the glass frame.
- Attach the screw caps (schraubkappe) to the designated areas.
- Use the provided profile screws (profile Schrauben ST3.9×9.5) to reinforce the structure.
- Complete the assembly by adding the end covers (end paper).
- Install the bottom seals for both the fixed and sliding glass panels.
- Attach the handle to the sliding glass panel.
After completing the installation, make sure to remove any protective film present on the product. Regularly clean the glass and profiles with a mild detergent solution to maintain their appearance.
FAQ
- Q: How do I remove the protective film after assembly?
- A: Simply peel off the protective film carefully from the surfaces of the product.
- Q: What should I do if I encounter missing parts during assembly?
- A: Contact our customer service at [customer service contact information] to request replacement parts.
Attention!
- installation of item should be carried out only by a qualified professional, following the instructions of this guidance;
- assembly is carried out by two persons;
- please, check for the presence of all details after unpacking. Glass panels must be transported vertically;
- please, lean glass panels vertically against the wall during the assembly of other parts;
- it is expressly prohibited to wap upon corners of glass panels
Recommendations for use
Attention!
- It is required to remove the protective film after carrying out of assembly operations.
Product maintenance
Attention
- for correct operation of the system, it is required to install purification filters at feed pipelines with a degree of purification of 100-300 microns.
- for the avoidance of damage of the surface of the product, it is not allowed to use water of temperature more than 60 degrees C.
- use only mild detergents and soap for cleaning of the item.
- do not use corrosive washing agents or abrasive pastes for cleaning of the item.
- accute contaminations on the surface is recommended to treat with diluted vinegar and washed off with water.
- shallow scratches (for acrylic parts of the item) can be removed with fine grid sandpaper (grade 2000)
- Instruction is designed for experts. Assembly and installation must be carried out only by qualified professionals following the instructions of this guideline.
Attention!
- Assembly is carried out by two persons.
- Manufacturer has a right to introduce changes of parts that has no effect on the appearance and functionality of the product.
- All parameters indicated in this instruction have formal meaning.
- The manufacturer reserves the right for technical changes.
Attention!
- After assembly sealant must be given some time to harden.
- It is forbidden to use item within 24 hours after completion of installation.
Dimension
TOOLS
PARTS
- wall profile x1
- dowel x3
- wall screw ST3.9×35 x3
- glass frame x1
- profile cover x2
- vertical seal x1
- screw cap x3
- profile screw ST3.9×9.5 x3
- end cover x2
- bottom seal of fixed glass x1
- bottom seal of sliding glass x1
- screw М3×8 x4
- handle x1
Installation Instructions
CONTACT
- AM.PM Europe GmbH
- Torstrasse 177 D-10115 Berlin
- www.ampm-world.com 07/2020
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>