Vtech IM 542700 Rescue Driver Atv and Fire Truck User Guide

June 13, 2024
vtech

Vtech IM 542700 Rescue Driver Atv and Fire Truck

Vtech-IM-542700-Rescue-Driver-Atv-and-Fire-Truck-
PRODUCT

We aim to reduce our environmental impact and have reduced the amount of paper used for our printed manuals. The full version of the manual is available online through the following link or by scanning the QR code.

INCLUDED IN THIS PACKAGE

  • One PAW Patrol Rescue Driver ATV & Fire Truck
  • Quick Start Guide

WARNINGVtech-IM-542700-Rescue-Driver-Atv-and-Fire-Truck-
FIG-1
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords, and packaging screws are not part of this toy and should be discarded for your child’s safety.

NOTE
Please keep this Quick Start Guide as it contains important information.

Unlock the Packaging Locks

  1. Rotate the packaging locks 90 degrees counterclockwise.
  2. Pull out the packaging locks and discard them.

GETTING STARTED

Battery Removal and Installation

  1. Make sure the unit is turned Off.
  2. Find the battery cover located on the bottom of the unit, use a screwdriver to loosen the screw, and then open the battery cover.
  3. Remove old batteries by pulling up on one end of each battery.
  4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
  5. Replace the battery cover and tighten the screw to secure it.

WARNING
Adult assembly is required for battery installation. Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

  • Insert batteries with the correct polarity (+ and -).
  • Do not mix old and new batteries.
  • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
  • Only batteries of the same or equivalent type as recommended are to be used.
  • Do not short-circuit the supply terminals.
  • Remove batteries during long periods of non-use.
  • Remove exhausted batteries from the toy.
  • Dispose of batteries safely. Do not dispose of batteries in a fire.

RECHARGEABLE BATTERIES

  • Remove rechargeable batteries (if removable) from the toy before charging.
  • Rechargeable batteries are only to be charged under adult supervision.
  • Do not charge non-rechargeable batteries.

CARE & MAINTENANCE

  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from any direct heat sources.
  3. Remove the batteries if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

  1. Turn the unit Off.
  2. Interrupt the power supply by removing the batteries.
  3. Let the unit stand for a few minutes, then replace the batteries.
  4. Turn the unit On. The unit should now be ready to use again.
  5. If the unit still does not work, install a new set of batteries.

IMPORTANT NOTE
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or go to our website vtechkids.com and fill out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CAN ICES-003(B)/NMB-003(B)

Supplier’s Declaration of Conformity 47 CFR § 2.1077
Compliance Information

  • Trade Name: VTech®
  • Model: 5427
  • Product Name: PAW Patrol Rescue Driver ATV & Fire Truck
  • Responsible Party: VTech Electronics North America, L.L.C.
  • Address: 1156 W. Shure Drive, Suite 200,
  • Arlington Heights, IL 60004
  • Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals