OTTER PRODUCTS OBFTC-0093-A Folding Wireless Charging Stand Instructions
- June 6, 2024
- OTTER PRODUCTS
Table of Contents
OTTER PRODUCTS OBFTC-0093-A Folding Wireless Charging Stand
SETUP
Attach Power Cable to Stand and to Wall Charger
WIRELESS CHARGING
- Lift and rotate pad to engage foot then adjust pad to desired angle
- Align device back with gold ring
- Place device on stand, wireless charging begins automatically
- Charge on stand while 4 Charge on stand while
LED BEHAVIOR
- LED flashes briefly during device recognition
- LED glows solid while charging
- LED flashes continuously on error; remove foreign object (e.g. metal) or move to cooler environment
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>