AIGOSTAR 330100A4W Remote Control Floor Fan Instruction Manual
- June 13, 2024
- aigostar
Table of Contents
AIGOSTAR 330100A4W Remote Control Floor Fan Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
- Before connecting the fan to the power supply, ensure the voltage of the power supply is compatible with the voltage marked on the fan’ s voltage label.
- Never leave the fan unattended during use.
- Keep the appliance out of reach of children or persons who are unable to handle electric appliances safely. Children must not play with the appliance.
- This appliance can be used by children aged 8 years and above if they have been given supervision or instruction concerning the safe use of the appliance and understand the hazards involved. Children must not perform cleaning and user maintenance without supervision.
- This appliance can be used by persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the safe use of the appliance and understand the hazards involved.
- The air outlet of the fan should not be directed at the elderly, sick, children, or pets.
- Whenever the appliance is not in use or before cleaning, unplug it from the power outlet. Always unplug the appliance by pulling the plug from the power outlet. Do not pull on the cord.
- The appliance must always be disconnected from the power supply after use, before assembly, or during transportation.
- Use this fan only as described in this manual. Using the fan for any purposes other than those described herein can cause fire or electric shock.
- Only use the appliance for domestic purposes. This appliance is not suitable for commercial use or use outdoors.
- The appliance should be placed on an even, clean, stable, and dry surface during use. Make sure that the fan can swing freely and any items do not obstruct its oscillating movement.
- Do not operate or place the device or any parts of the appliance in places of high humidity or where it may get wet.
- Do not use this appliance in the immediate surroundings of a bath, shower or swimming pool or in places where it may get wet.
- To protect against the risk of electric shock, do not immerse the unit, its cord, or its plug in water or any other liquid. If the appliance does get wet, immediately remove the power cord from the power supply and do not put your hands in the water.
- To prevent injury, do not place foreign objects, pencils, hands, etc. in the fan when the appliance is plugged in or in operation.
- Do not let the appliance’ s power cord hang over the edge of a table or bench edge or where a child can grab it. Do not allow the power cord to touch any warm surface.
- Always arrange the cord in a way that prevents pulling, tripping, or entanglement.
- Make sure that there are no hair, curtains, tablecloths or similar items near the fan. These items can be sucked into the fan and cause physical or material damage.
- Do not cover the fan with blankets, clothing, or similar items during use. The space above and around the fan must be kept clear at all times.
- Before connecting the plug to the power supply, make sure the appliance is turned off.
- Ensure that the cable does not touch any rotating parts of the appliance, other sharp edges, or hot objects.
- Do not operate the appliance if it malfunctions, is damaged, or has been dropped or damaged in any manner. Take the fan to an authorized service facility or qualified personnel for examination or repair.
- Never leave the power cable wrapped or coiled during use. Unwind it completely.
- Do not move the appliance when it is in operation.
- Do not touch the appliance with wet or damp hands.
- Do not use an extension power cord incombination with this appliance.
- This appliance is not intended to be operated using an external timer or separate remote-control system.
- Check the power cord periodically for possible damage.
- If the appliance’ s power cord or plug has been damaged, do not use it. Contact an authorized service facility for repairs.
- To ensure the air circulates properly around the motor, keep the air outlets at the rear of the motor clean.
- 0nly use original spare parts in combination with this appliance.
- If the fan is damaged or broken, do not attempt to repair it yourself; take it to an authorized service facility.
- The fan blades have sharp edges; please pay attention to safety when installing them and assembling the parts.
TECHNICAL SPECIFICATIONS
| Model No. | 330100A4W |
|---|---|
| Power Supply | 220-240 V ~ 50/60 Hz |
| Power Consumption | 60 W |
| Dimensions | L400W430H1200 MM |
The specifications and design are subject to change without notice.
PRODUCT OVERVIEW
- Fan guard ring
- Front fan grille
- Blade fixing nut
- Fan blade
- Rear grille support nut
- Rear fan grille
- Motor shaft
- Motor joint
- Control panel
- Motor fixing screw
- Inner tube
- Height fixing nut
- Base fixing nut
- Base
ASSEMBLY INSTRUCTIONS
Warning: Ensure the fan is disconnected from the power supply and turned off before commencing assembly.
ASSEMBLING THE BASE AND FAN MOTOR
-
Insert the tube through the hole in the centre of the base, and tightly screw the base fixing nut to the tube on the other side of the base.
-
Turn over the base and place it on a dry, level surface.
-
Unscrew the height fixing nut and pull up the [5) inner tube to adjust the height. Fix the height of the tube by tightly screwing the height fixing nut to the tube.
-
Put the motor unit onto the tube. Fix the o motor unit on the tube by tightly screwing the motor fixing screw to the tube on the back of the control panel.
ASSEMBLING THE BLADE AND GRILLE
-
Install the rear fan grille on the motor shaft by aligning the two narrow holes in the rear fan grille. Securely fasten the rear grille support nut.
-
Fit the fan blade on the motor shaft and fasten the blade fixing nut.
-
Put the fan guard ring in position without screwing it in place. Make sure the screw is at the bottom.
-
Install the front fan grille and tighten the guard ring’ s screw.
OPERATING INSTRUCTIONS
When the fan is connected to the power supply, the buzzer beeps once, and the fan goes into standby mode.
CAUTION:
- Before using, make sure all device parts are properly assembled and no parts have been damaged.
- Always place the device on a flat, dr?/, and stable surface. There is a risk of damage if the appliance is not installed on a flat and level surface.
I. Remote controller
a. KEY INSTRUCTIONS
-
“ ” ON/SPEED KEY
Press the “ON/SPEED” key to switch on the fan. The fan will start at the low-speed wind. When the fan starts, press this key repeatedly to make the fan cycle through the “low-speed wind,” “mid-speed wind,” and “high-speed wind” settings.
-
” ” FF KEY
Press the “OFF” key to switch the fan off. -
” ” MODE KeY
After the fan has started, press the “MODE” key to select the mode. Press it repeatedly to make the mode cycle through “normal mode” to “natural mode” to “sleep mode. 4″ © ” SWING KeY After the fan has started, press this key to select the swing/oscillation mode. -
” ” TIMER KEY
When the fan is operating, press the timer key repeatedly to set a shutdown time of up to 7.5 hours (in 0.5-hour increments). If you want to cancel the timing, short press consecutively the TIMER button on the control panel or the TIfl;/IER button on the remote controller until all the timer indicator lights turn off.
Note: All the selected functions will be shown on the control panel.
b. BATTERIES
-
Before first use: The batteries in the remote control are covered with a protec- tive film to prevent them from running out of power before first use. Pull out and remove the protective film. The remote controller is now ready for use.
-
Battery replacement:
-
The remote controller requires a 3V lithium button battery for operation. To install the battery, lace your thumb in the indentations and push it to the right, and then slide the attery compartment cover back (see Fig. 1).
-
Insert the new battery (Battery type CR2025) and make sure it is placed as shown in Fig. 2
-
Replace the battery cover.
c. BATTERY WARNINGS
- Do not dispose of the batteries in a fire as they may explode or leak.
- Do not mix old and new batteries.
d. REMOTE CONTROLLER OPERATION
Point the remote controller at the receptor on the body of the fan and press
the desired button. The remote controller will work from distances of up to
around 5 meters (16 feet) and at a 30-degree angle to the left and right of
the receptor. Before disposing of the remote controller, the batteries must
first be removed and disposed of safely.
II. Buttons on fan body/control panel
Caution: You can only change the mode of the fan via the remote
controller.
Other buttons on the body, such as ON/SPEED, OFF,TIMER, and SWING, have the
same functions as the corresponding keys on the remote controller. The
selected setting will be shown on the control panel indicator.
CLEANING AND MAINTENANCE
The fan requires little maintenance. Refer to qualified service personnel if service or repair is needed.
- The fan must be unplugged before cleaning and assembling.
- Wipe the exterior surfaces with a soft cloth soaked in a mild detergent. Thoroughly remove the soap film with a dry cloth.
- To avoid scratching the surface, do not use any abrasive detergent or solvents. Do not use gasoline or thinner as a cleaner.
- Do not allow water or any other liquid into the motor housing or interior parts.
DISPOSAL
As a responsible retailer, we care about the environment.
As such, we urge you to follow the correct disposal procedures for the
appliance and its packaging materials. This will help conserve natural
resources and ensure these items are recycled in a manner that protects health
and the environment.
You must dispose of the appliance and its packaging according to local laws
and regulations.
As this appliance contains electronic components, it and its accessories must
be disposed of separately from household waste when the appliance reaches the
end of its life.
Contact your local authority to learn about your disposal and recycling
options.
The appliance should be taken to your local recycling center. Some collection
points accept appliances free of charge.
WARRANTY: TWO YEARS
ITALIA MARKET SRL
VIA DELLE INDUSTRIE, 9/1 20883 MEZZAGO(MB), ITALIA P.IVA: IT10502730962
Documents / Resources
|
AIGOSTAR 330100A4W Remote Control Floor
Fan
[pdf] Instruction Manual
330100A4W Remote Control Floor Fan, 330100A4W, Remote Control Floor Fan,
Control Floor Fan, Floor Fan, Fan
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>