JONES STEPHENS 9781446 3 Inch Adjustable Flush Valve Kit Instructions

JONES STEPHENS 9781446 3 Inch Adjustable Flush Valve Kit

REMOVE TOILET TANK

1. Shut off water supply to toilet tank.
2. Disconnect water supply.
3. Remove nuts washers and bolts.
4. Lift tank off bowl.
5. Remove sponge gasket.
6. Remove mounting nut with a wrench.
7. Remove old flush valve.

FLUSH VALVE AND TANK TO BOWL GASKET INSTALLATION

1. Install new flush valve, rubber seal inside, washer on underside of tank. Hand tighten nut.
2. Place sponge gasket over mounting nut.
3. Place tank on bowl and assemble hardware.
4.  Tank will wobble initially. Apply downward pressure to tank with hand to keep tank level. Alternate tightening each hex nut until tank is stable and level.
5. Use adjustable wrench to tighten hex nuts if needed. Do not continue tightening if tank and bowl touch. Do not overtighten as the tank may crack.
6. Connect chain to flush lever, adjust its length long enough to seat/seal against flush valve seat surface.

ADJUST OVERFLOW TUBE HEIGHT

1. Pull up on the tube to raise it to the desired height.
2. Push down to lower

ADJUST WATER USAGE

Turn globe on bottom of flapper to the left (A – towards “-”) to use less water, and right ( A – towards “+”) to use more water during flush.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>