GE CYNC Indoor Smart Camera Installation Guide

: June 13, 2024
: GE

Table of Contents

Let’s Do It
- INCLUDED
- YOU”LL NEED
Mounting with Screws
Mounting with Removable Adhesive Strips
Mount Camera to Wall
Incorrect Wall Plate Position
Incorrect Wall Plate Position
Incorrect Cable and Camera Position
Storing Content on the Camera
Additional Information and Warnings
Simple Setup
Read User Manual Online (PDF format)
Download This Manual (PDF format)

GE CYNC Indoor Smart Camera

Let’s Do It

INCLUDED

Camera
Mounting Bracket
Drywall Anchor
Philips Mounting Screws
Removable Tape
Power Supply
Power Cord

YOU”LL NEED

Philips Screwdriver
Drill

Approximately 30 minutes to install and setup

Mounting with Screws

Remove Bracket from Bottom of the Camera Identify Placement, Drill Holes

Mounting with Screws

Mounting with Removable Adhesive Strips

Remove Bracket from Bottom of the Camera Identify Placement, Attach Adhesive

Mounting with Removable Adhesive Strips

Mount Camera to Wall

Mount to Flat, Smooth Surface

Incorrect Wall Plate Position

The Camera can also mount to ceilings or upside down. Easily flip the image 180° in the CYNC app for these installations.

Incorrect Wall Plate Position

Incorrect Cable and Camera Position

Storing Content on the Camera

Additional Information and Warnings

FCC Compliance Statement Compliance Notice:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:

This device may not cause interference;
This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.

Symbol Like your new CYNC Smart Camera?
Share your experience!