Shenzhen Opuri Technology GT888 LED RGB Controller User Manual
- June 5, 2024
- Shenzhen Opuri Technology
Table of Contents
Shenzhen Opuri Technology GT888 LED RGB Controller
SPECIFICATIONS
- Remote Distance: 20M
- Operating Temp.: -20°C 60°C
- Dimming Method: PWM
- Grey Steps: 256/CH
- Common Anode
Remote
- Power Supply AAA Battery * 3PCs
- Standby Power Consumption: 0.05mW
Receiver
- Input: DC 12V~24V
- Output: Max 6A/CH, RGB 3CHs (Normal) Max 10A/CH, RGB 3CHs (Optional)
Unit Instruction
Mechanical Info
Wiring Example
Pair the Remote to a Receiver
For some particular application, if you want one Remote only control one
Receiver, then the Receiver is required to be paired to the Remote. Here below
is the guide.
Before any action, setup the controller correctly:
- Load the Batteries into the Remote.
- Connect LED to the Receiver.
- Connect the Receiver to the Power Supply.
Pairing the Receiver to the Remote.
- Switch off the main power supply to the Receiver.
- Restore power, and within 6 seconds, sync depress the two buttons more than 2second, as picture.
- If the LED flash, that mean the successful pairing process.
- If the LED don’t flash, repeat the step1 to step2.
CAUTIONS:
- Do not expose the components of this product direct moisture,
- Do not expose the components of this product to excessively high temperatures.
- Please keep out of reach of children.
- Please consult your owner’s manual and/or local dealer if issues arise.
- Do NOT mix alkaline, standard and rechargeable Batteries.
- Do NOT mix old and new Batteries.
- Exhausted Batteries should be removed immediately from the Remote.
- The supply terminals are not to be short-circuited.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.